NetBSD-Users archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: HP Deskjet F380 All-in-One on NetBSD

On Mon, Nov 21, 2011 at 06:14:54PM +0530, Mayuresh wrote:
> hp-setup / hp-check /hp-formuri - nobody recognizes the printer.
> The printer is connected, pwoered on, is not in any error state and has
> been working on Linux.
> dmesg shows the printer is recognized by kernel and set as /dev/ulpt0. So
> no problem with the cable etc.
> Stuck. Any help will be appreciated.
Do you have ulpt enabled in the kernel config?

There was a message that ulpt should not be enabled in the kernel or as a 
module with hplip.
This was for both NetBSD pkgsrc and FreeBSD ports.

I've been unable to get my printer, HP n1212mf, working in NetBSD or FreeBSD 
with hplip.
So far, I tried only with USB, will want to also try the Ethernet.

I couldn't get the printer to work with Linux, Slackware 13.0, working, but 
that may have been because that version of hplip was too old.

In all cases, the predominant problem was no devices found.


Home | Main Index | Thread Index | Old Index