Re: Auto-configuration question

[buhrow%lothlorien.nfbcal.org@localhost (Brian Buhrow)]

        Hello.  Now that you're moving toward using raidframe with
auto-configure turned on, this will become less of a problem as the raid
sets will show up in the right order and, no matter where the disks are,
raidframe will configure them in the right locations.

-Brian

On May 9, 11:10am, Paul Goyette wrote:
} Subject: Re: Auto-configuration question
} On Mon, 9 May 2011, Brian Buhrow wrote:
} 
} >     Hello.  What do you get if you just let the     bus numbers float?
} > i.e.
} >
} >     {163} config -x | grep ixpide0
} >     ixpide0         at pci0 dev 20 function 1
} >     atabus?         at ixpide0 channel 0
} >     atabus?         at ixpide0 channel 1
} >     {164}
} > -Brian
} 
} Everything works if I let everything float, but when it comes to my 
} disks, I like to have them hard-wired.  Otherwise, /etc/fstab entries 
} could mount the wrong partitions in strange places.
} 
} 
} -------------------------------------------------------------------------
} | Paul Goyette     | PGP Key fingerprint:     | E-mail addresses:       |
} | Customer Service | FA29 0E3B 35AF E8AE 6651 | paul at whooppee.com    |
} | Network Engineer | 0786 F758 55DE 53BA 7731 | pgoyette at juniper.net |
} | Kernel Developer |                          | pgoyette at netbsd.org  |
} -------------------------------------------------------------------------
>-- End of excerpt from Paul Goyette