Hi --
Easiest way to get going is to install an image from my site:
http://www.invisible.ca/arm
There are images available for OrangePi One (and a pile of other
boards) updated daily. Just write to SD card and boot!
Cheers,
Jared
On Tue, 10 Jul 2018, s_graf%telus.net@localhost wrote:
I am new to netbsd and am trying to run on an orange pi one. Is
there a better set of instructions to follow than:
https://github.com/jaredmcneill/netbsd-arm-docs/wiki/Allwinner
I am getting this result:
U-Boot SPL 2017.11 (Jun 22 2018 - 06:03:40)
DRAM: 512 MiB
Trying to boot from MMC1
U-Boot 2017.11 (Jun 22 2018 - 06:03:40 +0000) Allwinner Technology
CPU: Allwinner H3 (SUN8I 1680)
Model: Xunlong Orange Pi One
DRAM: 512 MiB
MMC: SUNXI SD/MMC: 0
In: serial
Out: serial
Err: serial
Net: phy interface0
eth0: ethernet@1c30000
starting USB...
USB0: USB EHCI 1.00
USB1: USB OHCI 1.0
scanning bus 0 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot: 0
reading netbsd-SUNXI.ub
5814932 bytes read in 280 ms (19.8 MiB/s)
** Unable to read file sun8i-h3-orangepi-one.dtb **
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
## Booting kernel from Legacy Image at 42000000 ...
Image Name: NetBSD/sunxi 8.0_RC2
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 5814868 Bytes = 5.5 MiB
Load Address: 40008000
Entry Point: 40008000
Verifying Checksum ... OK
ERROR: Did not find a cmdline Flattened Device Tree
Could not find a valid device tree
=>