Re: first attempt to run netbsd on orange pi one

[Jared McNeill <jmcneill%invisible.ca@localhost>]

Hi --

Easiest way to get going is to install an image from my site:

  http://www.invisible.ca/arm

There are images available for OrangePi One (and a pile of other boards) 
updated daily. Just write to SD card and boot!

Cheers,
Jared


On Tue, 10 Jul 2018, s_graf%telus.net@localhost wrote:

> I am new to netbsd and am trying to run on an orange pi one.  Is there a better set of instructions to follow than:
>
> https://github.com/jaredmcneill/netbsd-arm-docs/wiki/Allwinner
>
>  
>
> I am getting this result:
>
>  
>
> U-Boot SPL 2017.11 (Jun 22 2018 - 06:03:40)
>
> DRAM: 512 MiB
>
> Trying to boot from MMC1
>
>  
>
>  
>
> U-Boot 2017.11 (Jun 22 2018 - 06:03:40 +0000) Allwinner Technology
>
>  
>
> CPU:   Allwinner H3 (SUN8I 1680)
>
> Model: Xunlong Orange Pi One
>
> DRAM:  512 MiB
>
> MMC:   SUNXI SD/MMC: 0
>
> In:    serial
>
> Out:   serial
>
> Err:   serial
>
> Net:   phy interface0
>
> eth0: ethernet@1c30000
>
> starting USB...
>
> USB0:   USB EHCI 1.00
>
> USB1:   USB OHCI 1.0
>
> scanning bus 0 for devices... 1 USB Device(s) found
>
>        scanning usb for storage devices... 0 Storage Device(s) found
>
> Hit any key to stop autoboot:  0
>
> reading netbsd-SUNXI.ub
>
> 5814932 bytes read in 280 ms (19.8 MiB/s)
>
> ** Unable to read file sun8i-h3-orangepi-one.dtb **
>
> libfdt fdt_check_header(): FDT_ERR_BADMAGIC
>
> ## Booting kernel from Legacy Image at 42000000 ...
>
>    Image Name:   NetBSD/sunxi 8.0_RC2
>
>    Image Type:   ARM Linux Kernel Image (uncompressed)
>
>    Data Size:    5814868 Bytes = 5.5 MiB
>
>    Load Address: 40008000
>
>    Entry Point:  40008000
>
>    Verifying Checksum ... OK
>
> ERROR: Did not find a cmdline Flattened Device Tree
>
> Could not find a valid device tree
>
> =>