I am new to netbsd and am trying to run on an orange pi one. Is there a better set of instructions to follow than: https://github.com/jaredmcneill/netbsd-arm-docs/wiki/Allwinner I am getting this result: U-Boot SPL 2017.11 (Jun 22 2018 - 06:03:40) DRAM: 512 MiB Trying to boot from MMC1 U-Boot 2017.11 (Jun 22 2018 - 06:03:40 +0000) Allwinner Technology CPU: Allwinner H3 (SUN8I 1680) Model: Xunlong Orange Pi One DRAM: 512 MiB MMC: SUNXI SD/MMC: 0 In: serial Out: serial Err: serial Net: phy interface0 eth0: ethernet@1c30000 starting USB... USB0: USB EHCI 1.00 USB1: USB OHCI 1.0 scanning bus 0 for devices... 1 USB Device(s) found scanning usb for storage devices... 0 Storage Device(s) found Hit any key to stop autoboot: 0 reading netbsd-SUNXI.ub 5814932 bytes read in 280 ms (19.8 MiB/s) ** Unable to read file sun8i-h3-orangepi-one.dtb ** libfdt fdt_check_header(): FDT_ERR_BADMAGIC ## Booting kernel from Legacy Image at 42000000 ... Image Name: NetBSD/sunxi 8.0_RC2 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 5814868 Bytes = 5.5 MiB Load Address: 40008000 Entry Point: 40008000 Verifying Checksum ... OK ERROR: Did not find a cmdline Flattened Device Tree Could not find a valid device tree => |