Re: mvsata problem

[KIYOHARA Takashi <kiyohara%kk.iij4u.or.jp@localhost>]

Hi! Mark,


From: Mark Davies <mark%ecs.vuw.ac.nz@localhost>
Date: Thu, 14 Oct 2010 21:03:56 +1300

> I've plugged an Adaptec 1420SA pci-x card into a Dell PowerEdge 2600.  If I 
> boot current on the box with no disks attached to the card I get the dmesg 
> output that is attached at the end of this.  However if I attach a single 
> sata disk to the card the machine crashes on boot with this:
> 
> uhub0 at usb0...
> mvsata0 port 3: device present, speed: 3.0 Gb/s
> mvsata0 port 7: device present, speed: 3.0 Gb/s
> wd0 at atabus3 derive 0: <ST31000528AS>
> wd0: 931 GB, 1938021 cyl, 16 head, 63 sec, 512 bytes/sect x 1953525168 
> sectors
> fatal page fault in supervisor mode
> trap type 6 code 0 eip c07871a1 cs 8 eflags 10246 cr2
> Stopped in pid 0.2(system) at netbsd:wdcintr+0xc1: call *0x30(%ebx)
> 
> backtrace gives:
> 
> wdintr(...)
> mvsata_intr(...)
> mvsata_pci_intr(...)
> intr_biglock_wrapper(...)

Can you try rebuilded kernel with MVSATA_DEBUG and ATADEBUG again?

Thanks,
--
kiyohara