Motorola MTX Board

[Joerg Anton <joerga%ranet.de@localhost>]

Hello,

I have got a used Motorola MTX board. I put 2  128MByte ECC Edo Dimms 
(unbuffered) in the ram slots.  I connect minicom to the first serial 
port and power on the maschine. Next the output:

/*****************************************************/
Copyright Motorola Inc. 1988 - 1998, All Rights Reserved

PPC1 Debugger/Diagnostics Release Version 4.1 - 10/12/98 RM01
COLD Start

Local Memory Found =10000000 (&268435456)

WARNING: Configuration Data Failure (Invoke 'ENV' Command)

MPU Clock Speed =300Mhz

WARNING: MPU Clock Speed Does Not Match the Board Configuration

BUS Clock Speed =67Mhz

WARNING: BUS Clock Speed Does Not Match the Board Configuration

WARNING: Keyboard Not Connected

Reset Vector Location  : ROM Bank B
Mezzanine Configuration: Twin-MPU
Current 60X-Bus Master : MPU0
Idle MPU(s)            : MPU1

Initializing System Memory (DRAM)...

/*****END******/

and then the mashine stand .
The green and the yellow led on the board are on. The yellow led is the 
board fail led, wich goes on when the board cannot finish the selftest.
Is the board broken or need I other memory? I have only this 2 modules 
and I cannot test these modules in a other mashine. Can anybody help me?

bye joerg