Re: No ethernet card with Olimex Lime 2

[picani%laposte.net@localhost]

I've done some other tries.

With the file lime2.fex.gz send by jymn
or with the full FEX script for Lime2 (https://raw.githubusercontent.com/linux-sunxi/sunxi-boards/master/sys_config/a20/a20-olinuxino_lime2.fex),
or even without FEX script, the card boot and all seams working but the 
ethernet card.

In all situations, I got the following, one or two times in dmesg output :
awge0 at awinio0: Gigabit Ethernet Controller 
awge0: interrupting on irq 117 
awge0: reset timed out 


I use the lime2 uboot available at :
http://dl.linux-sunxi.org/nightly/u-boot-sunxi/u-boot-sunxi-mainline/u-boot-sunxi-mainline-latest/

and the following uboot commands since the uEnx.txt is not taken into account 
by uboot :

setenv bootargs root=ld0a sysconfig=0x43000000 
fatload mmc 0:1 43000000 a20-olinuxino_lime2.bin
fatload mmc 0:1 82000000 
netbsd.ub; bootm 82000000 

I don't know what's going on ... Any ideas ?


> Hi,
> 
> > On 24 May 2015, at 18:20 , Picani <picani%laposte.net@localhost> wrote:
> > 
> > Does anyone have the ethernet card working for this board ?
> 
> You must use the lime2 uboot, found here:
> 
> http://dl.linux-sunxi.org/nightly/u-boot-sunxi/u-boot-sunxi-mainline/u-boot-> sunxi-mainline-latest/
> 
> The board should boot fine (with ethernet) with it.
> 
> You can also replace the fex script by the one for lime2 (must be compiled
> with sunxi tools), but it is not mandatory.
> 
> 
> The full script is here:
> https://github.com/linux-sunxi/sunxi-boards/tree/master/sys_config/a20
> 
> But as I’m unable to boot with the full fex script, I shrinked it to the
> minimum for NetBSD: