Re: [guruplug] mvgbe1 no PHY found

[Ignatios Souvatzis <is%netbsd.org@localhost>]

On Tue, Feb 08, 2011 at 07:30:33PM +0100, Freddy DISSAUX wrote:
 
> If someone have idea/patch for the 'mvgbe1: no PHY found!' ...


Read closer - it *is* found, but on the wrong ethernet device:

> mvgbec0 at mvsoc0 unit 0 offset 0x70000-0x73fff: Marvell Gigabit Ethernet 
> Controller
> mvgbe0 at mvgbec0 port 0 irq 11
> mvgbe0: Ethernet address 00:50:43:01:85:d4
> mvgbe_jumbo_buf = 0xc289f000
> mvgbe_stop

> makphy0 at mvgbe0 phy 0: Marvell 88E1149 Gigabit PHY, rev. 3
> makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
> 1000baseT-FDX, auto 

> makphy1 at mvgbe0 phy 1: Marvell 88E1149 Gigabit PHY, rev. 3
> makphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
> 1000baseT-FDX, auto

> mvgbec1 at mvsoc0 unit 1 offset 0x74000-0x77fff: Marvell Gigabit Ethernet 
> Controller
> mvgbe1 at mvgbec1 port 0 irq 14
> mvgbe1: Ethernet address 00:50:43:01:85:d5
> mvgbe_jumbo_buf = 0xc2bf8000
> mvgbe_stop
> mvgbe1: no PHY found!


Somebody familiar with the driver or Marvell's documentation will have
to think about this...

Regards,
        -is