[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
Re: Serial port programming
> I have a LCD character display connected to a uslsa(4) USB-to-serial bridge.
> It is programmed using escape sequences that are sent at 9600 bps, no parity,
> 8 databits, 1 stop bit (9600 8N1). I am trying to send escape sequences
> using the attached small C program, but it does not work. Is anything worng
> with that program? (I am at the same looking at the kernel driver, btw).
> It does not work neither on NetBSD 5, -current, nor on FreeBSD nor on Linux.
This problem is solved. The display needed an undocumented setup command to be
sent prior to all other commands.
Thanks to all who replied!
Main Index |
Thread Index |