Re: working against 5.99.44: AR8131/2 driver

[fire crow <fire%firecrow.com@localhost>]

On Wed, Feb 2, 2011 at 4:19 PM, Ignatios Souvatzis <is%netbsd.org@localhost> 
wrote:
> I booted with alcdebug set to 1. Firecrow - can you do that, too, please?
>
> On Wed, Feb 02, 2011 at 09:22:44PM +0100, Ignatios Souvatzis wrote:
> ...
>> ppb1 at pci0 dev 28 function 1: vendor 0x8086 product 0x27d2 (rev. 0x02)
>> ppb1: PCI Express 1.0 <Root Port of PCI-E Root Complex>
>> pci2 at ppb1 bus 2
>> pci2: i/o space, memory space enabled, rd/line, wr/inv ok
>> alc0 at pci2 dev 0 function 0: Attansic/Atheros L1E Ethernet
>> alc0: ioapic0 pin 17
>
> alc0: Read request size : 128 bytes.
> alc0: TLP payload size : 128 bytes.
> alc0: PCI device revision : 0x00c0
> alc0: Chip id/revision : 0xc002
> alc0: 15872 Tx FIFO, 15360 Rx FIFO
>
>> alc0: Ethernet address 00:26:18:15:30:39
>> atphy0 at alc0 phy 0: L1 10/100/1000 PHY, rev. 11
>> atphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, auto
>
>

lost my current, partition, being my reckelss self, so I'll need to
set it back up to get those results,

but I did run into one of the error conditions you mentioned earlier
while putting it back together,

5.1_RC3 userland, 5.99.39 kernel - gave me those atphy0 timeouts, lost
of em and nothing else

+
| fire crow
| computer programmer
!_____________________

  http://firecrow.com, fire%firecrow.com@localhost, 917.306.9451, New York 
City, USA