Re: RTL8169S/8110S not supported on 4.0_STABLE?

[Brad du Plessis <bradd%cat.co.za@localhost>]

Izumi Tsutsui wrote:
> Anyway, could you try diffs only against rgephy.c
> and rgephyreg.h first?
>   

Ok I tried this, see results below.

Thanks,
Brad

ifconfig re0:

re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
   
capabilities=3f80<TSO4,IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx,TCP4CSUM_Tx,UDP4CSUM_Rx,UDP4CSUM_Tx>
   enabled=0
   address: 00:00:00:00:00:00
   media: Ethernet autoselect (none)
   status: no carrier


dmesg:

--snip--
re0 at pci2 dev 0 function 0pci_mem_find: void region
: RealTek 8168B/8111B PCIe Gigabit Ethernet (rev. 0x02)
re0: interrupting at ioapic0 pin 17 (irq 10)
re0: Unknown revision (0x3c000000)
re0: Ethernet address 00:00:00:00:00:00
re0: using 256 tx descriptors
rgephy0 at re0 phy 7: RTL8169S/8110S 1000BASE-T media interface, rev. 2
rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
1000baseT-FDX, auto
--snip--