[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
RAIDframe: stripe unit per reconstruction unit
The man page says:
The stripe units per parity unit and stripe units per reconstruction unit
are normally each set to 1. While certain values above 1 are permitted,
a discussion of valid values and the consequences of using anything other
than 1 are outside the scope of this document.
I noticed that reconstruction seems to read/write in units of one stripe unit,
which in my case (being 4k) seems rather inefficient. Is it possible to
accelerate recontruction by using a figure larger than 1 here?
Main Index |
Thread Index |