Port-xen archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: NetBSD/Xen Howto



Manuel Bouyer schrieb:

xm console tell you this when you start it.
Only if you switch from dom0 to domU by the 'xm console' command.
If you go up to domU with the command 'xm create -c' you don't get this information.

It does for me:
lavardin:/home/bouyer>xm create -c /usr/pkg/etc/xen/lavardin1
Using config file "/usr/pkg/etc/xen/lavardin1".
Started domain lavardin1, console on port 9603
************ REMOTE CONSOLE: CTRL-] TO QUIT ********
Loaded initial symtab at 0xc048812c, strtab at 0xc04b67d0, # entries 11806
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
   The NetBSD Foundation, Inc.  All rights reserved.

Mh. I don't see this. I did try this now a few times. Maybe my Computer start the domU to fast so i didn't
see this message ;)

Well, you are right. No problem. But if i do so the shutdown seam to hang after haltet.

If you run shutdown without -p you get:
The operating system has halted.
Please press any key to reboot.

and pressing a key indeed reboots :)
That's true. For me too. :)

shutdown -p will cause the domain to shutdown and destroy once shutdown
is complete.

At my environment not that way, that it brings me back to dom0.
It just stay at this message without the dom0 prompt.
So i have to use Ctrl + ]





Home | Main Index | Thread Index | Old Index