Port-arm archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: Status of run0 on armv7 NetBSD 8.0_RC1 rpi2

On Wed, Jun 13, 2018 at 06:47:23PM +0000, maya%netbsd.org@localhost wrote:
> You can make wpa more informative by running it like this:
> wpa_supplicant -i run0 -c /etc/wpa_supplicant.conf # -d extra noisy and
> probably not needed

Already shared that one of the last mails!

> Most notably, I have this problem if people setup the AP in 802.11n only
> mode. It is visible only when scanning but authentication times out.
> NetBSD does not support 802.11n yet. I've had to change APs to
> "802.11b/g/n compatibility mode" a few times.

Will try and report. Thanks.


Home | Main Index | Thread Index | Old Index