Status of run0 on armv7 NetBSD 8.0_RC1 rpi2

[Mayuresh <mayuresh%acm.org@localhost>]

Just want to check whether run0 is expected to work on the following
setup:

# uname -a
NetBSD armv7 8.0_RC1 NetBSD 8.0_RC1 (RPI2.201804240813Z) evbarm


# dmesg | grep run0
run0 at uhub1 port 3
run0: Ralink (0x148f) 802.11 n WLAN (0x5370), rev 2.00/1.01, addr 4
run0: MAC/BBP RT5390 (rev 0x0502), RF RT5592 (MIMO 1T1R), address
00:c1:00:c1:94:b6
run0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
run0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
run0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
24Mbps 36Mbps 48Mbps 54Mbps

# wpa_cli status
Selected interface 'run0'
20:31:07.754: wpa_state=SCANNING
address=00:c1:00:c1:94:b6

wpa_cli status always shows scanning only.

I have done /etc/rc.conf and /etc/wpa_supplicant.conf settings as per
the following link and don't think there is any problem with them:
https://wiki.netbsd.org/tutorials/how_to_use_wpa_supplicant/

It had got connected all of a sudden once, something I could not repeat.

Mayuresh