RE: Thunder h2000M (S3992-E)

["Derrick Lobo" <derrick%givex.com@localhost>]

Thanks Paul yes it does not support Phenom... besides Phenom is more a
processor for desktops... So I will be using Opteron 2000 as per specs
listed earlier..

The question remains has anyone got this to work with Netbsd 4.0..

Is the Adaptec AIC-9405/9410 SAS controller supported...

-----Original Message-----
From: Paul Goyette [mailto:paul%whooppee.com@localhost] 
Sent: Wednesday, May 07, 2008 7:54 PM
To: Derrick Lobo
Cc: port-amd64%NetBSD.org@localhost
Subject: Re: Thunder h2000M (S3992-E)

I think the Phenom takes an AM2 socket, which is slightly different from 
the sockets for Opteron or Barcelona...  Check first!

On Wed, 7 May 2008, Derrick Lobo wrote:

> Anyone got this motherboard working with Netbsd 4.0.. Please let me know I
> plan to get one with an AMD  Phenom Quad core processor.. It has an
adaptech
> SAS controller....
>
> -------------
> Specs listed below as per tya.com
>
> Thunder h2000M (S3992-E)
> Processor
> *  Two uPGA 1207-pin ZIF sockets
> *  Supports up to two AMD Opteron(tm) Rev. F
>    2000 Series Santa Rosa dual-core processors,
>    and Barcelona quad-core processors
> *  Support AMD Dual Dynamic Power Management
>   feature
> *  Integrated 128-bit DDR Memory Controller
>
> Chipset
> *  BCM5780(HT2000) + BCM5785(HT1000) chipset
> *  SCH4307 Super I/O chip
>
> Memory
> *  128-bit dual channel memory bus
> *  Total sixteen(16) 240-pin 1.8-Volt DDRII DIMM
>    sockets (8 on CPU1 and 8 on CPU2)
> *  Supports up to DDRII 667MHz
> *  Registered, ECC module supported
>
> Expansion Slots
> *  Two (2) PCI Express x16 slots (each w/ x8 signal)
> *  Two (2) PCI-X 133/100MHz slot
> *  One (1) PCI-X 100MHz slot
> *  One (1) PCI 32-bit 33MHz, v2.3 compliant slot
> *  One ( 1 ) Tyan "TARO" SO-DIMM socket
>
> Integrated I/O
> *  One floppy connector
> *  One IDE connector
> *  Four SATA ports
> *  Four USB 2.0 p orts ( 2 at rear, 2 via cable)
> *  Two COM port ( 1 at rear, 1 via cable)
> *  Tyan 2 x 9 front-panel pin header
> *  Tyan 2 x 6 front-panel pin header for LAN/ID LED
> *  Tyan 2 x 7 pin header ( 2.0mm ) for FAN
>    tachometer and PWM.
> *  2 x 25 connector for optional Tyan IPMI SMDC
>
> Back Panel I/O Ports
> *  Stacked PS/2 Mouse & Keyboard ports
> *  Stacked 2 USB ports and 1 10/100 RJ45 ports
> *  One 9-pin COM port
> *  One 15-pin VGA port
> *  Two side-by-side RJ-45 ports
>
> Power
> * Onboard dual 4-phase VRM
> * EPS12V/SSI v3.51 (24 + 8) power connectors
>
> Form Factor
> * Extended ATX footprint (13" x 12")
> * EPS12V/ATX12V universal power connectors
>
> Regulatory
> * FCC Class B (DoC)
> * European Community CE (DoC)
>
> System Management
> *  (2) EMC6D103 H/W monitor chips
> *  (8) 3 +1 -pin fan headers support tachometer
>   monitoring, six of them with smart FAN control
> *  Temperature and voltage monitoring
> *  Watchdog timer support
>
> Integrated Video Controller
> *  ATIR ES1000 controller
> *  32MB DDR frame buffer
>
> Integrated Enhanced IDE Controller
> *  Single-ch. master mode: up to two IDE devices
> *  Supports IDE drives & ATAPI-compliant devices
>
> Integrated Serial ATA Controller
> *  (4) SATA ports at 1.5Gb/s with NCQ supported.
> *  RAID 0, 1, 5, and 10 supported
>
> Integrated LAN Controllers
> *  Dual GbE LAN (from BCM5780)
>   - Embedded in BCM5780
>   - Two 10/100/1000 RJ-45 LAN ports w/ LED
> *  One Intel i 82551QM fast Ethernet controller
>   - One 10/100 RJ-45 LAN port w/ LED
>   - Operating on 32bit/33MHz PCI bus
>
> BIOS
> * AMI BIOS on 8Mbit LPC Flash ROM
> * ACPI 2.0 and SRAT support
> * PnP, DMI 2.0, WfM 2.0 Power Management
> * PXE via Ethernet, USB device boot
> * SMBIOS 2.3.1, BBS 1.1 compliant
> * Headless Operation via serial console redirect
> * 48-bit LBA support
>
> Optional modules
> * M3291, IPMI 2.0 Remote System Mgmt card
>   - Renesas H8S2167 BMC controller
>   - BT, KCS, Logging support
>   - IPMI-over-LAN
>   - Remote power on/off and reset
>
> * M7901/M7902, Ultra 320 SCSI "TARO" card
>   - Adaptec AIC-7901/7902 single/dual-channel
>     Ultra320 SCSI controller
>   - Adaptec HostRAID 0, 1, 10 supported
>   - IPMI-over-LAN
>
> * M9000 SAS/SATA II "TARO" card
>   - Adaptec AIC-9405/9410 SAS controller
>   - Supports up to 4-port (M9000-5) and 8-port
>     (M9000-10) SAS & SATA running at 3.0Gb/s
>   - Adaptec HostRAID 0, 1 & 10 supported
>
>
>
>
>
>
> !DSPAM:48223bd21771096581986!
>
>
>

----------------------------------------------------------------------
|   Paul Goyette   | PGP DSS Key fingerprint: |  E-mail addresses:   |
| Customer Service | FA29 0E3B 35AF E8AE 6651 |  paul%whooppee.com@localhost   |
| Network Engineer | 0786 F758 55DE 53BA 7731 | pgoyette%juniper.net@localhost |
----------------------------------------------------------------------