Anyone got this motherboard working with Netbsd 4.0.. Please let me know I
plan to get one with an AMD Phenom Quad core processor.. It has an adaptech
SAS controller....
-------------
Specs listed below as per tya.com
Thunder h2000M (S3992-E)
Processor
* Two uPGA 1207-pin ZIF sockets
* Supports up to two AMD Opteron(tm) Rev. F
2000 Series Santa Rosa dual-core processors,
and Barcelona quad-core processors
* Support AMD Dual Dynamic Power Management
feature
* Integrated 128-bit DDR Memory Controller
Chipset
* BCM5780(HT2000) + BCM5785(HT1000) chipset
* SCH4307 Super I/O chip
Memory
* 128-bit dual channel memory bus
* Total sixteen(16) 240-pin 1.8-Volt DDRII DIMM
sockets (8 on CPU1 and 8 on CPU2)
* Supports up to DDRII 667MHz
* Registered, ECC module supported
Expansion Slots
* Two (2) PCI Express x16 slots (each w/ x8 signal)
* Two (2) PCI-X 133/100MHz slot
* One (1) PCI-X 100MHz slot
* One (1) PCI 32-bit 33MHz, v2.3 compliant slot
* One ( 1 ) Tyan "TARO" SO-DIMM socket
Integrated I/O
* One floppy connector
* One IDE connector
* Four SATA ports
* Four USB 2.0 p orts ( 2 at rear, 2 via cable)
* Two COM port ( 1 at rear, 1 via cable)
* Tyan 2 x 9 front-panel pin header
* Tyan 2 x 6 front-panel pin header for LAN/ID LED
* Tyan 2 x 7 pin header ( 2.0mm ) for FAN
tachometer and PWM.
* 2 x 25 connector for optional Tyan IPMI SMDC
Back Panel I/O Ports
* Stacked PS/2 Mouse & Keyboard ports
* Stacked 2 USB ports and 1 10/100 RJ45 ports
* One 9-pin COM port
* One 15-pin VGA port
* Two side-by-side RJ-45 ports
Power
* Onboard dual 4-phase VRM
* EPS12V/SSI v3.51 (24 + 8) power connectors
Form Factor
* Extended ATX footprint (13" x 12")
* EPS12V/ATX12V universal power connectors
Regulatory
* FCC Class B (DoC)
* European Community CE (DoC)
System Management
* (2) EMC6D103 H/W monitor chips
* (8) 3 +1 -pin fan headers support tachometer
monitoring, six of them with smart FAN control
* Temperature and voltage monitoring
* Watchdog timer support
Integrated Video Controller
* ATIR ES1000 controller
* 32MB DDR frame buffer
Integrated Enhanced IDE Controller
* Single-ch. master mode: up to two IDE devices
* Supports IDE drives & ATAPI-compliant devices
Integrated Serial ATA Controller
* (4) SATA ports at 1.5Gb/s with NCQ supported.
* RAID 0, 1, 5, and 10 supported
Integrated LAN Controllers
* Dual GbE LAN (from BCM5780)
- Embedded in BCM5780
- Two 10/100/1000 RJ-45 LAN ports w/ LED
* One Intel i 82551QM fast Ethernet controller
- One 10/100 RJ-45 LAN port w/ LED
- Operating on 32bit/33MHz PCI bus
BIOS
* AMI BIOS on 8Mbit LPC Flash ROM
* ACPI 2.0 and SRAT support
* PnP, DMI 2.0, WfM 2.0 Power Management
* PXE via Ethernet, USB device boot
* SMBIOS 2.3.1, BBS 1.1 compliant
* Headless Operation via serial console redirect
* 48-bit LBA support
Optional modules
* M3291, IPMI 2.0 Remote System Mgmt card
- Renesas H8S2167 BMC controller
- BT, KCS, Logging support
- IPMI-over-LAN
- Remote power on/off and reset
* M7901/M7902, Ultra 320 SCSI "TARO" card
- Adaptec AIC-7901/7902 single/dual-channel
Ultra320 SCSI controller
- Adaptec HostRAID 0, 1, 10 supported
- IPMI-over-LAN
* M9000 SAS/SATA II "TARO" card
- Adaptec AIC-9405/9410 SAS controller
- Supports up to 4-port (M9000-5) and 8-port
(M9000-10) SAS & SATA running at 3.0Gb/s
- Adaptec HostRAID 0, 1 & 10 supported
!DSPAM:48223bd21771096581986!