Thunder h2000M (S3992-E)

["Derrick Lobo" <derrick%givex.com@localhost>]

Anyone got this motherboard working with Netbsd 4.0.. Please let me know I
plan to get one with an AMD  Phenom Quad core processor.. It has an adaptech
SAS controller.... 

-------------
Specs listed below as per tya.com

Thunder h2000M (S3992-E)
Processor
*  Two uPGA 1207-pin ZIF sockets
*  Supports up to two AMD Opteron(tm) Rev. F
    2000 Series Santa Rosa dual-core processors,
    and Barcelona quad-core processors
*  Support AMD Dual Dynamic Power Management
   feature
*  Integrated 128-bit DDR Memory Controller

Chipset
*  BCM5780(HT2000) + BCM5785(HT1000) chipset
*  SCH4307 Super I/O chip

Memory
*  128-bit dual channel memory bus
*  Total sixteen(16) 240-pin 1.8-Volt DDRII DIMM
    sockets (8 on CPU1 and 8 on CPU2)
*  Supports up to DDRII 667MHz
*  Registered, ECC module supported

Expansion Slots
*  Two (2) PCI Express x16 slots (each w/ x8 signal)
*  Two (2) PCI-X 133/100MHz slot
*  One (1) PCI-X 100MHz slot
*  One (1) PCI 32-bit 33MHz, v2.3 compliant slot
*  One ( 1 ) Tyan "TARO" SO-DIMM socket

Integrated I/O
*  One floppy connector
*  One IDE connector
*  Four SATA ports
*  Four USB 2.0 p orts ( 2 at rear, 2 via cable)
*  Two COM port ( 1 at rear, 1 via cable)
*  Tyan 2 x 9 front-panel pin header
*  Tyan 2 x 6 front-panel pin header for LAN/ID LED
*  Tyan 2 x 7 pin header ( 2.0mm ) for FAN
    tachometer and PWM.
*  2 x 25 connector for optional Tyan IPMI SMDC

Back Panel I/O Ports
*  Stacked PS/2 Mouse & Keyboard ports
*  Stacked 2 USB ports and 1 10/100 RJ45 ports
*  One 9-pin COM port
*  One 15-pin VGA port
*  Two side-by-side RJ-45 ports

Power
 * Onboard dual 4-phase VRM
 * EPS12V/SSI v3.51 (24 + 8) power connectors

Form Factor
 * Extended ATX footprint (13" x 12")
 * EPS12V/ATX12V universal power connectors

Regulatory
 * FCC Class B (DoC)
 * European Community CE (DoC)

System Management
*  (2) EMC6D103 H/W monitor chips
*  (8) 3 +1 -pin fan headers support tachometer
   monitoring, six of them with smart FAN control
*  Temperature and voltage monitoring
*  Watchdog timer support

Integrated Video Controller
*  ATIR ES1000 controller
*  32MB DDR frame buffer

Integrated Enhanced IDE Controller
*  Single-ch. master mode: up to two IDE devices
*  Supports IDE drives & ATAPI-compliant devices

Integrated Serial ATA Controller
*  (4) SATA ports at 1.5Gb/s with NCQ supported. 
*  RAID 0, 1, 5, and 10 supported

Integrated LAN Controllers
*  Dual GbE LAN (from BCM5780)
   - Embedded in BCM5780
   - Two 10/100/1000 RJ-45 LAN ports w/ LED
*  One Intel i 82551QM fast Ethernet controller
   - One 10/100 RJ-45 LAN port w/ LED
   - Operating on 32bit/33MHz PCI bus 

BIOS
 * AMI BIOS on 8Mbit LPC Flash ROM
 * ACPI 2.0 and SRAT support
 * PnP, DMI 2.0, WfM 2.0 Power Management
 * PXE via Ethernet, USB device boot
 * SMBIOS 2.3.1, BBS 1.1 compliant
 * Headless Operation via serial console redirect
 * 48-bit LBA support

Optional modules
 * M3291, IPMI 2.0 Remote System Mgmt card
   - Renesas H8S2167 BMC controller
   - BT, KCS, Logging support
   - IPMI-over-LAN
   - Remote power on/off and reset

 * M7901/M7902, Ultra 320 SCSI "TARO" card
   - Adaptec AIC-7901/7902 single/dual-channel
     Ultra320 SCSI controller
   - Adaptec HostRAID 0, 1, 10 supported
   - IPMI-over-LAN

 * M9000 SAS/SATA II "TARO" card
   - Adaptec AIC-9405/9410 SAS controller
   - Supports up to 4-port (M9000-5) and 8-port
     (M9000-10) SAS & SATA running at 3.0Gb/s
   - Adaptec HostRAID 0, 1 & 10 supported