Port-alpha archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Current Kernel does not boot



Aaron J. Grier schrieb:
On Tue, Oct 21, 2008 at 10:43:15PM +0200, Jan Lentfer wrote:
So first off, what can I contribute to actually keep the development
of NetBSD/Alpha ongoing? Is just running -current enough or are there
more things that can be done (I am no developer, though, but quite
able to patch, compile, etc ....).

more eyeballs with -current always helps

So, I decided to do that right away and followed chapter 32 of the netbsd guide. After installing the new kernel und doing the reboot (before installing userland) I get the following on the serial console:

Digital Personal WorkStation 500au
Console V7.2-1 Mar  6 2000 14:47:02
>>>boot dra0
(boot dra0.0.0.1009.0 -flags A)
block 0 of dra0.0.0.1009.0 is a valid boot block
reading 13 blocks from dra0.0.0.1009.0
bootstrap code read in
base = 1d8000, image_start = 0, image_bytes = 1a00
initializing HWRPB at 2000
initializing page table at 1ca000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code

NetBSD/alpha 4.0 FFS Primary Bootstrap
Jumping to entry point...

NetBSD/alpha 4.0 Secondary Bootstrap, Revision 1.13
(builds@wb27, Sat Dec 15 21:19:56 PST 2007)

VMS PAL rev: 0x1000000010114
OSF PAL rev: 0x1000000020116
Switch to OSF PAL code succeeded.

Boot flags: A
6001088+440432 [353208+228924]=0x6b32a8

Entering netbsd at 0xfffffc0000301110...
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
   2006, 2007, 2008
   The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
   The Regents of the University of California.  All rights reserved.

NetBSD 4.99.73 (PWS_MLX) #0: Sat Oct 25 16:34:04 UTC 2008
       
lentferj%bsd-alpha.lan.net@localhost:/usr/obj/sys/arch/alpha/compile/PWS_MLX
Digital Personal WorkStation 500au, 500MHz, s/n
8192 byte page size, 1 processor.
total memory = 448 MB
(1896 KB reserved for PROM, 446 MB used by NetBSD)
avail memory = 432 MB
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164A-0
cpu0: Architecture extensions: 1<BWX>
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (Pyxis), pass 1
cia0: extended capabilities: 1<BWEN>
cia0: using BWX for PCI config access
cia0: WARNING: Pyxis pass 1 DMA bug; no bets...
pci0 at cia0 bus 0
tlp0 at pci0 dev 3 function 0: DECchip 21143 Ethernet, pass 3.0
tlp0: interrupting at dec 550 irq 0
tlp0: DEC, Ethernet address 00:00:f8:75:69:1a
tlp0: unable to configure MII
tlp0: 10baseT, 10baseT-FDX, 10base2, 10base5, auto
pciide0 at pci0 dev 4 function 0
pciide0: CMD Technology PCI0646 (rev. 0x01)
pciide0: primary channel ignored (not responding; disabled or no drives?)
pciide0: secondary channel interrupting at isa irq 15
atabus0 at pciide0 channel 1
sio0 at pci0 dev 7 function 0: Intel 82378ZB System I/O (rev. 0x43)
ppb0 at pci0 dev 20 function 0: Digital Equipment DC21052 PCI-PCI Bridge (rev. )
pci1 at ppb0 bus 1
mlx0 at pci1 dev 9 function 0: Mylex RAID (v2 interface)
mlx0: interrupting at dec 550 irq 16
mlx0: DAC960P/PD, 3 channels, firmware 2.70-0-00, 32MB RAM
ld0 at mlx0 unit 0: RAID1, online
ld0: 4094 MB, 2079 cyl, 64 head, 63 sec, 512 bytes/sect x 8384512 sectors
ld1 at mlx0 unit 1: JBOD, online
ld1: 4094 MB, 2079 cyl, 64 head, 63 sec, 512 bytes/sect x 8384512 sectors
tlp1 at pci1 dev 10 function 0: DECchip 21143 Ethernet, pass 4.1
tlp1: interrupting at dec 550 irq 20
tlp1: Ethernet address 00:c0:ca:34:06:7b
tlp1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
isa0 at sio0
lpt0 at isa0 port 0x3bc-0x3bf irq 7
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
pckbc0 at isa0 port 0x60-0x64
attimer0 at isa0 port 0x40-0x43: AT Timer
sb0 at isa0 port 0x220-0x237 irq 5 drq 1: dsp v3.01
audio0 at sb0: half duplex, mmap, independent
opl at sb0 not configured
pcppi0 at isa0 port 0x61
midi0 at pcppi0: PC speaker (CPU-intensive output)
spkr0 at pcppi0
isabeep0 at pcppi0
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
mcclock0 at isa0 port 0x70-0x71: mc146818 compatible time-of-day clock
attimer0: attached to pcppi0
atapibus0 at atabus0: 2 targets
cd0 at atapibus0 drive 0: <TOSHIBA CD-ROM XM-5702B, 8500815666, 3476> cdrom reme
Kernelized RAIDframe activated

CPU 0: fatal kernel trap:

CPU 0    trap entry = 0x2 (memory management fault)
CPU 0    a0         = 0x4a
CPU 0    a1         = 0x1
CPU 0    a2         = 0x0
CPU 0    pc         = 0xfffffc00005b5810
CPU 0    ra         = 0xfffffc00003e9740
CPU 0    pv         = 0xfffffc00005b5810
CPU 0    curlwp     = 0xfffffc001beb9c00
CPU 0        pid = 0, comm = system

panic: trap
Stopped in pid 0.2 (system) at netbsd:cpu_Debugger+0x4: ret zero,(ra
)
db>


Kind Regards,

Jan Lentfer



Home | Main Index | Thread Index | Old Index