Re: Setting default route and specify interface to be used

To: Rocky Hotas <rockyhotas%firemail.cc@localhost>
Subject: Re: Setting default route and specify interface to be used
From: Robert Elz <kre%munnari.OZ.AU@localhost>
Date: Thu, 12 Dec 2019 01:07:45 +0700

    Date:        Wed, 11 Dec 2019 18:49:41 +0100
    From:        Rocky Hotas <rockyhotas%firemail.cc@localhost>
    Message-ID:  <20191211174941.qujrbqx4x44pddbz@delpotro>

  | Is there a way to perform this configuration in NetBSD, as in Linux?

From route(8) - the manual page for the route command ...

     In a change or add command where the destination and gateway are not
     sufficient to specify the route the -ifp or -ifa modifiers may be used to
     determine the interface or interface address.

Try that.

kre

Follow-Ups:
- Re: Setting default route and specify interface to be used
  - From: Rocky Hotas

References:
- Setting default route and specify interface to be used
  - From: Rocky Hotas

Prev by Date: Setting default route and specify interface to be used
Next by Date: Re: No HDMI output on Lenovo V145, NetBSD 8.0
Previous by Thread: Setting default route and specify interface to be used
Next by Thread: Re: Setting default route and specify interface to be used
Indexes:

Home | Main Index | Thread Index | Old Index