NetBSD-Users archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: cdrecord DMA speed too slow error on 6.0 BETA2



On Sat, Jun 02, 2012 at 12:58:27PM -0500, Dave Huang wrote:
> from your other machine. If it's not using DMA, that would probably
> explain your burning problem. Information about your IDE controller
> must be somewhere in the dmesg... atapibus0 is attached to atabus0, so
> grep for atabus0 and see where that's attached. That should be your
> IDE controller, so grep for that.

I saw it says - no driver support. I am using GENERIC kernel. Do I require
compiling it in?

$ dmesg | grep pciide
pciide0 at pci2 dev 0 function 0: vendor 0x11ab product 0x6101 (rev. 0xb1)
pciide0: bus-master DMA support present, but unused (no driver support)
pciide0: primary channel configured to native-PCI mode
pciide0: using ioapic0 pin 17 for native-PCI interrupt
atabus0 at pciide0 channel 0
pciide0: secondary channel configured to native-PCI mode
atabus1 at pciide0 channel 1

Mayuresh


Home | Main Index | Thread Index | Old Index