Re: extracting base.tgz hangs

[Emil Skoeldberg <esg%SDF.ORG@localhost>]

On Wed, May 18, 2011 at 06:44:47PM -0400, Jason Mitchell wrote:
> Hello,
> 
> Did you post output from dmesg? That would be a big help in troubleshooting 
> this.
> 

No, I didn't, but it follows:

Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 4.0 (GENERIC.MP) #0: Sun Dec 16 00:47:41 PST 2007
        
builds@wb34:/home/builds/ab/netbsd-4-0-RELEASE/i386/200712160005Z-obj/home/builds/ab/netbsd-4-0-RELEASE/src/sys/arch/i386/compile/GENERIC.MP
total memory = 97916 KB
rbus: rbus_min_start set to 0x20000000
avail memory = 85616 KB
timecounter: Timecounters tick every 10.000 msec
timecounter: Timecounter "i8254" frequency 1193182 Hz quality 100
BIOS32 rev. 0 found at 0xfb4a0
mainbus0 (root)
ACPI Error (tbxfroot-0775): No valid RSDP was found [20060217]
ACPI Exception (tbxfroot-0531): AE_NOT_FOUND, RSDP structure not found - 
Flags=8 [20060217]
ACPI Exception (tbxface-0162): AE_NO_ACPI_TABLES, Could not get the RSDP 
[20060217]
ACPI Exception (tbxface-0211): AE_NO_ACPI_TABLES, Could not load tables 
[20060217]
ACPI: unable to load tables: AE_NO_ACPI_TABLES
mainbus0: Intel MP Specification (Version 1.1) (OEM00000 PROD00000000)
cpu0 at mainbus0: apid 0 (boot processor)
cpu0: Intel Pentium/MMX (586-class), 167.05 MHz, id 0x543
cpu0: features 8003bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,APIC>
cpu0: features 8003bf<MMX>
cpu0: calibrating local timer
cpu0: apic clock running at 66 MHz
cpu1 at mainbus0: apid 1 (application processor)
cpu1: starting
cpu1: Intel Dual Pentium/MMX (586-class), 167.05 MHz, id 0x2543
cpu1: features 8003bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,APIC>
cpu1: features 8003bf<MMX>
mpbios: bus 0 is type PCI   
mpbios: bus 1 is type ISA   
ioapic0 at mainbus0 apid 2 (I/O APIC)
ioapic0: pa 0xfec00000, version 11, 24 pins
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok
pchb0 at pci0 dev 0 function 0
pchb0: Intel 82439HX (TXC) System Controller (rev. 0x03)
pcib0 at pci0 dev 7 function 0
pcib0: Intel 82371SB (PIIX3) PCI-ISA Bridge (rev. 0x01)
piixide0 at pci0 dev 7 function 1
piixide0: Intel 82371SB IDE Interface (PIIX3) (rev. 0x00)
piixide0: bus-master DMA support present
piixide0: primary channel wired to compatibility mode
piixide0: primary channel interrupting at ioapic0 pin 14 (irq 14)
atabus0 at piixide0 channel 0
piixide0: secondary channel wired to compatibility mode
piixide0: secondary channel interrupting at ioapic0 pin 15 (irq 15)
atabus1 at piixide0 channel 1
vga1 at pci0 dev 8 function 0: S3 Trio64V2/DX (rev. 0x16)
wsdisplay0 at vga1 kbdmux 1: console (80x25, vt100 emulation)
wsmux1: connecting to wsdisplay0
rtk0 at pci0 dev 9 function 0: Realtek 8139 10/100BaseTX (rev. 0x10)
rtk0: interrupting at ioapic0 pin 17 (irq 10)
rtk0: Ethernet address 00:10:a7:22:ec:04
rlphy0 at rtk0 phy 7: Realtek internal PHY
rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
rtk1 at pci0 dev 10 function 0: Realtek 8139 10/100BaseTX (rev. 0x10)
rtk1: interrupting at ioapic0 pin 18 (irq 9)
rtk1: Ethernet address 00:90:47:03:ba:f0
rlphy1 at rtk1 phy 7: Realtek internal PHY
rlphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
ahc1 at pci0 dev 12 function 0: Adaptec aic7880 Ultra SCSI adapter
ahc1: interrupting at ioapic0 pin 19 (irq 5)
ahc1: Using left over BIOS settings
ahc1: aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs
scsibus0 at ahc1: 16 targets, 8 luns per target
isa0 at pcib0
lpt0 at isa0 port 0x378-0x37b irq 7
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
pckbc0 at isa0 port 0x60-0x64
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
attimer0 at isa0 port 0x40-0x43: AT Timer
pcppi0 at isa0 port 0x61
pcppi0: children must have an explicit unit
midi0 at pcppi0: PC speaker (CPU-intensive output)
sysbeep0 at pcppi0
isapnp0 at isa0 port 0x279: ISA Plug 'n Play device support
npx0 at isa0 port 0xf0-0xff
npx0: reported by CPUID; using exception 16
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
pcppi0: attached to attimer0
isapnp0: no ISA Plug 'n Play devices found
ioapic0: enabling
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
Kernelized RAIDframe activated
scsibus0: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 6 lun 0: <IBM, DORS-32160W, WC0A> disk fixed
sd0: 2063 MB, 6703 cyl, 5 head, 126 sec, 512 bytes/sect x 4226725 sectors
sd0: sync (100.00ns offset 8), 16-bit (20.000MB/s) transfers, tagged queueing
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs
cpu1: CPU 1 running
wsdisplay0: screen 1 added (80x25, vt100 emulation)
wsdisplay0: screen 2 added (80x25, vt100 emulation)
wsdisplay0: screen 3 added (80x25, vt100 emulation)
wsdisplay0: screen 4 added (80x25, vt100 emulation)


/Emil

-- 
esg%sdf.lonestar.org@localhost
SDF Public Access UNIX System - http://sdf.lonestar.org