[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
RE: Can't build version 5 kernel
> -----Original Message-----
> From: netbsd-users-owner%NetBSD.org@localhost
> [mailto:netbsd-users-owner%NetBSD.org@localhost] On Behalf Of Daniel Horecki
> Sent: Sunday, July 19, 2009 12:41 PM
> To: Michael D. Spence
> Cc: netbsd-users%netbsd.org@localhost
> Subject: Re: Can't build version 5 kernel
> On Sun, Jul 19, 2009 at 08:01:08AM -0400, Michael D. Spence wrote:
> > I am setting up a version 5 system from scratch. I burned
> the V5 iso
> > and successfully installed it on the targeted computer, an old HP
> > Pavilion 7955. While the GENERIC kernel can see the NICs, it gets
> > an error (can't map device registers) and the NICs aren't available.
> > I looked into generating a custom kernel. I downloaded the source
> > sets and put them on the target system and created a new
> > file to enable some PCI fixups that I though might be useful.
> > I then followed the instructions in Chapter 31 of the
> NetBSD Guide to
> > compile
> > the new kernel. I keep getting ioconf.o (.data+0x6238):
> undefined reference
> > to 'stfattach'
> > Does anyone have any suggestions on what could be going wrong?
> Probably you disabled IPV6 and not stf device in kernel config. Either
> enable IPV6 or disable stf.
I did disable IPV6. As it turned out, I didn't need to build a custom
after all but I probably will want to do so later, so I will keep this in
Michael D. Spence
Mockingbird Data Systems, Inc.
Main Index |
Thread Index |