[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
RE: issues with LSI 9260
Is netbsd able to see the drives if they are setup as JBOD on your
controller.. One of the issue is that netbsd cannot recognize the drives
when I have them setup as JBOD on the LSI controller. I would prefer going
that route so that I can then setup netbsd RAID instead.
From: Manuel Bouyer [mailto:bouyer%antioche.eu.org@localhost]
Sent: Thursday, May 28, 2015 11:57 AM
To: Derrick Lobo
Cc: netbsd-users%NetBSD.org@localhost; netbsd-ports%NetBSD.org@localhost;
Subject: Re: issues with LSI 9260
On Thu, May 28, 2015 at 11:53:26AM -0400, Derrick Lobo wrote:
> The config we have 4 x 2tb disk with raid10 setup on the lsi .. the
> disk is configured using gpt
> Im not seeing any errors in normal operation or on the kernel however
> when we build a database we get these errors on the postgress logs
> Block 1077542 of base/16391/24778
> Block 848733 of base/16391/24777
I have no idea what this means. Are you sure this is errors ?
> These are certrans and certificate, respectively.
> dd if=/data_local/cert63/base/16391/24778.16 of=badpage.certrans.63
> bs=16384 count=1 skip=28966
> dd if=/data_local/cert63/base/16391/24777.12 of=badpage.certificate.63
> bs=16384 count=1 skip=62301
Does this report errors ?
> when we take off the lsi and connect a sata disk and use gpt to
> configure the drive we are able to build the database with no page
It may also be timing-related, I would expect the LSI to be much faster,
especially for writes
Manuel Bouyer <bouyer%antioche.eu.org@localhost>
NetBSD: 26 ans d'experience feront toujours la difference
Main Index |
Thread Index |