Re: wm devices don't work under current amd64

[Masanobu SAITOH <msaitoh%execsw.org@localhost>]

Hi.

On 2016/03/07 21:12, Tobias Nygren wrote:
> On Mon, 7 Mar 2016 20:57:02 +0900
> Masanobu SAITOH <msaitoh%execsw.org@localhost> wrote:
>
> > One of the possibility is that the multicast filter table and broadcast
> > bit in a register aren't set correctly on ICH9.
>
> I'm not sure if this is relevant to the discussion, but I have a wm(4)
> device (8086:1502) on -current that does not work after boot. It comes
> to life only after running "tcpdump -n -i wm0" once. I am using vlan(4),
> but haven't checked if that makes any difference. I usually run the
> tcpdump command then forget about it until the next reboot.

 It must be a bug! Could you tell me how you set up network interface include
vlan? (e.g. part of /etc/rc.conf, /etc/ifconfig.xxx, and the output of "ifconfig -a)

> wm0 at pci0 dev 25 function 0: PCH2 LAN (82579LM) Controller (rev. 0x06)
> wm0: interrupting at msi0 vec 0
> wm0: PCI-Express bus
> wm0: 2048 words FLASH
> wm0: Ethernet address xx:xx:xx:xx:xx:xx
> ihphy0 at wm0 phy 2: i82579 10/100/1000 media interface, rev. 3
> ihphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> 1000baseT-FDX, auto


--
-----------------------------------------------
                SAITOH Masanobu (msaitoh%execsw.org@localhost
                                 msaitoh%netbsd.org@localhost)