Re: Can't recognize USB memory card reader on 6.99.24

[Thomas Klausner <wiz%NetBSD.org@localhost>]

On Mon, Oct 14, 2013 at 08:17:30AM +0900, Jun Ebihara wrote:
> Does anybody use typical memory card reader in 6.99.24?

Sure, looks like this in dmesg:

umass0 at uhub4 port 4 configuration 1 interface 0
umass0: Genesys Logic USB Storage, rev 2.00/97.27, addr 6
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, 5 luns per target
sd0 at scsibus0 target 0 lun 0: <Generic, STORAGE DEVICE-A, 9727> disk removable
sd0: fabricating a geometry
sd0: 30518 MB, 30518 cyl, 64 head, 32 sec, 512 bytes/sect x 62500864 sectors
sd0: fabricating a geometry
sd1 at scsibus0 target 0 lun 1: <Generic, STORAGE DEVICE-A, 9727> disk removable
sd1: drive offline
sd2 at scsibus0 target 0 lun 2: <Generic, STORAGE DEVICE-A, 9727> disk removable
sd2: drive offline
sd3 at scsibus0 target 0 lun 3: <Generic, STORAGE DEVICE-A, 9727> disk removable
sd3: drive offline
sd4 at scsibus0 target 0 lun 4: <Generic, STORAGE DEVICE-A, 9727> disk removable
sd4: drive offline
sd2(umass0:0:0:2):  Check Condition on CDB: 0x00 40 00 00 00 00
   SENSE KEY:  Not Ready
    ASC/ASCQ:  Medium Not Present

sd2(umass0:0:0:2):  Check Condition on CDB: 0x00 40 00 00 00 00
   SENSE KEY:  Not Ready
    ASC/ASCQ:  Medium Not Present

sd1(umass0:0:0:1):  Check Condition on CDB: 0x00 20 00 00 00 00
   SENSE KEY:  Not Ready
    ASC/ASCQ:  Medium Not Present

sd1(umass0:0:0:1):  Check Condition on CDB: 0x00 20 00 00 00 00
   SENSE KEY:  Not Ready
    ASC/ASCQ:  Medium Not Present


That's a cheap HAMA "ALL IN 1 CARD READER", USB 2.0, attached to a USB
port on my monitor.
 Thomas