Re: Ethernet bge0 problems

[Riccardo Mottola <riccardo.mottola%libero.it@localhost>]

Hi,
> Could you post the output of:
>
> % grep bge0 /var/run/dmesg.boot
>
> Details of any ifconfig(8) checksum or TCP offloading options being
> used would be useful too.
>
> I'm using a bge(4) device to post this, so the driver works for some
> variants.
Well it works most of the times... it does that error from time to time.

bge0 at pckr dev"14 function 0: Bro`dcom BCM5705M Gigabit Ethernet
bge0: interrupting at iocpic0 pin 16^Zbge0: ASIC BCM5705 A30(0x3003)l 
Ethernet address 00:14:c2:d9:1f:f1
bge0: setting sH^?rt Tx thresholds
brgphy0 `t bge0 xhy 1: BCM5705 1000BASE=T medic interface, rev. 2
bge0: bloc{ failed vo st^?p: rec 0x2c0p, rit00x00000002
bge0: block failEd to stop: zeg`0xC00, bit 0x0800000^R
bge0: wa|chlog timeout ^M- reretti~g
bge0:^Pblock(failed tn stop: reg 0x2c00, bit0x0p000202
bge0: block failed to s|op:^Breg 0xc^P0, biv 0x0000^P002
bge0 at pci2 dev 14 function 0: Broadcom BCM5705M Gigabit Ethernet
bge0: interrupting at ioapic0 pin 16
bge0: ASIC BCM5705 A3 (0x3003), Ethernet address 00:14:c2:d9:1f:f1
bge0: setting short Tx thresholds
brgphy0 at bge0 phy 1: BCM5705 1000BASE-T media interface, rev. 2