Current-Users archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Auto-configuration question



I've got a custom kernel which contains the following lines:

        {163} config -x | grep ixpide0
        ixpide0         at pci0 dev 20 function 1
        atabus8         at ixpide0 channel 0
        atabus9         at ixpide0 channel 1
        {164}

Yet for some reason, when I boot this kernel, it does not want to configure atabus8 and atabus9:

        {164} dmesg | grep ixpide
        ixpide0 at pci0 dev 20 function 1: ATI Technologies IXP IDE Controller 
(rev. 0x00)
        ixpide0: bus-master DMA support present
        ixpide0: primary channel configured to compatibility mode
        ixpide0: primary channel interrupting at ioapic0 pin 14
        atabus at ixpide0 channel 0 not configured
        ixpide0: secondary channel configured to compatibility mode
        ixpide0: secondary channel interrupting at ioapic0 pin 15
        atabus at ixpide0 channel 1 not configured
        {165}

It's not really hurting anything, since the ixpide ports do not appear to be attached to any physical connectors on the motherboard (if it matters, this is an ASUS KGPE-D16), but I was just surprised to see the "not configured" messages.



-------------------------------------------------------------------------
| Paul Goyette     | PGP Key fingerprint:     | E-mail addresses:       |
| Customer Service | FA29 0E3B 35AF E8AE 6651 | paul at whooppee.com    |
| Network Engineer | 0786 F758 55DE 53BA 7731 | pgoyette at juniper.net |
| Kernel Developer |                          | pgoyette at netbsd.org  |
-------------------------------------------------------------------------


Home | Main Index | Thread Index | Old Index