ral0 at pci2 dev 2 function 0: Ralink Technologies RT2561S 802.11b/g (rev. 0x00)
ral0: interrupting at ioapic1 pin 17
ral0: 802.11 address xx:xx:xx:xx:xx:xx
ral0: MAC/BBP RT2561C, RF RT2527
ral0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ral0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
24Mbps 36Mbps 48Mbps 54Mbps
I could configure the network, it automatically found the correct SSID
and channel. The "TX rate (actual speed)" in wiconfig dropped and
dropped until it was at "1"; I couldn't ping the access point:
PING ap (192.168.0.1): 56 data bytes
ping: sendto: Host is down
...