[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
very long delay at ugen0 at uhub5 port 6
I updated from 4.0_RC4 to 4.99.55 on i386.
My dmesg is at http://reedmedia.net/~reed/tmp-nb73459yt/dmesg.boot
Now when I reboot, I get two long delays:
atapibus0 at atabus2: 2 targets
cd0 at atapibus0 drive 0: <MATSHITADVD-RAM UJ-850S, HB88 482625, 1.21>
...about a minute here...
cd0: 32-bit data port
cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (Ultra/33)
cd0(ixpide1:0:0): using PIO mode 4, Ultra-DMA mode 2 (Ultra/33) (using
(I might be confused here, as when I wrote this down I didn't see the
three lines above. I though the one minute delay was between "cd0 at
atapibus0" and "ugen0 at uhub5 port 6".)
ugen0 at uhub5 port 6
...about 30 seconds here...
ugen0: Realtek RTL8187B_WLAN_Adapter, rev 2.00/2.00, addr 3
boot device: wd0
I didn't have these delays with 4.0_RC4.
Should I report this to port-i386 list instead? Should I ignore it as it
My dmesg is at
Jeremy C. Reed
Main Index |
Thread Index |