Re: biowait for seconds

[Emmanuel Dreyfus <manu%netbsd.org@localhost>]

On Fri, Apr 18, 2025 at 04:22:09PM +0100, Robert Swindells wrote:
> Maybe read the suggestion as "find out why it isn't using msi".

I am back with some results with this. 

The nvme is available from a BOSS-N1 RAID controller. It is confgurable
from the BIOS and is able to export one RAID made of one or two NVME
(two in my case, but I tested one, no difference). It is not able to 
export the two NVME as-is. Removing the RAID set from the controller 
cause a nvme0ns1 (0 bytes) device to appear, and the biowait lags are
gone (but the NVME cannot be used, of course). 

I added many printfs to understand what is going on. MSI is not enabled
because the host bridge does not support it happens in 
sys/arch/x86/pci/pci_msi_machdep.c:pci_msix_alloc_common()

We have:
ppb0 at pci0 dev 10 function 0: Intel product 1bba (rev. 0x11)
pci1 at ppb0 bus 1
nvme0 at pci1 dev 0 function 0: Marvell product 2241 (rev. 0x20)
nvme0: NVMe 1.3
nvme0: interrupting at ioapic0 pin 16
nvme0: Dell BOSS-N1, firmware 11131069, serial VN0WW56VFCV004A801TY
ld0 at nvme0 nsid 1

pcictl pci0 dump -b 0 -d 10 -f 0 says:
(...)
  Capability register at 0x90
    type: 0x05 (MSI)
(...)
  PCI Message Signaled Interrupt
    Message Control register: 0x0100
      MSI Enabled: off

Hence the question is now how to enable MSI?




-- 
Emmanuel Dreyfus
manu%netbsd.org@localhost