Re: Cannot see boot messages with DomU

[Ronald Roskens <ronr%econet.com@localhost>]

On Mon, 2008-02-11 at 07:41 -0600, John Hayward wrote:
> On Mon, 11 Feb 2008, Manuel Bouyer wrote:
> 
> >> vif = [ 'mac=aa:00:00:50:02:f0, bridge=bridge0' ]
> >
> > does bridge0 exists in dom0 ?
> I should have included the following info:
> ====
> /etc/ifconfig.bridge0
> newserver: {3} cat /etc/ifconfig.bridge0
> create
> !brconfig $int add re0 up
> newserver: {4} ifconfig bridge0
> bridge0: flags=41<UP,RUNNING> mtu 1500
> newserver: {5} ifconfig re0
> re0: flags=8b43<UP,BROADCAST,RUNNING,PROMISC,ALLMULTI,SIMPLEX,MULTICAST> 
> mtu 1500
> 
> capabilities=3f80<TSO4,IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx,TCP4CSUM_Tx,UDP4CSUM_Rx,UDP4CSUM_Tx>
>          enabled=0
>          address: 00:1a:4d:59:1e:44
>          media: Ethernet autoselect (100baseTX full-duplex)
>          status: active
>          inet 10.0.0.7 netmask 0xffff0000 broadcast 10.0.255.255
>          inet6 fe80::21a:4dff:fe59:1e44%re0 prefixlen 64 scopeid 0x1
> ===
> 
> So I think bridge0 is configured and working.

and the output from brconfig bridge0?

Did you copy /usr/pkg/share/examples/xen/vif-bridge
to /usr/pkg/etc/xen/scripts/?

-r