re: RAIDframe swap problems?

[matthew green <mrg%eterna.com.au@localhost>]

>    I've been rebuilding a SS20 with netbsd-6.  I had an issue where it
> panic'd when I tried to bring a second drive on as a spare for the
> raidframe (RAID1), but I was able to reboot and perform that operation
> again without incident.
> 
>    But, now that I think I have the whole thing completed, I see the
> following when I boot:
> 
> Checking for core dump...
> savecore: kvm_read: invalid address (0xf03e4e30)
> 
>    Is this something that is happening because I've configured a RAID1
> as swap space?  I know this is known to work on sparc64 (and I'm doing
> so on one), or is this just some other issue that popped up here and
> isn't important?

can you show us your "raidctl -s raid0" output, as well as the
disklabel present on raid0?  thanks.

>    Thanks...  More of my boot log is attached below.
> 
>                                                        - Chris
> 
> [...]
> raid0: RAID Level 1
> raid0: Components: /dev/sd0a /dev/sd1a
> raid0: Total Sectors: 17595776 (8591 MB)
> rot on raid0a dumps on raid0b
> rot file system type: ffs
> Fri May  4 17:26:42 GMT 2012
> Starting root file system check:
> /dev/rraid0a: file system is clean; not checking
> swapctl: setting dump device to /dev/raid0b
> swapctl: adding /dev/raid0b as swap device at priority 0
> Starting file system checks:
[ ... ]
> Checking for core dump...
> savecore: kvm_read: invalid address (0xf03e4e30)
> Starting local daemons:.
> [...]


.mrg.