filtdelay= 0.23 0.23 0.23 0.23 0.23 0.37 0.23 0.26,
filtoffset= -0.06 -0.06 -0.07 -0.08 -0.08 -0.01 -0.01 -0.01,
filtdisp= 0.00 0.96 1.95 2.94 3.95 4.91 5.81 5.84
The last three lines are the ones from ctl_putarray().
Thanks for digging into this. Your test program is close what I had
it mind. I was thinking output only the hex values followed by \r to
avoid scrolling the terminal for speed, expecting when it went into an
infinite loop, the interesting hex value would be visible. AGC, what
does your ntpq show if you try similar commands, varying from&1 to
the number of associations? 'rv&X' happens under the hood for each
line of ntpq -p, and -c raw shows the text as it is on the wire (at
least for these filt*=).
Cheers,
Dave Hart