Re: netbsd-9, boot, EFI and device tree

[tlaronde%polynum.com@localhost]

Hello,

On Fri, Apr 23, 2021 at 10:02:37PM +0200, Manuel Bouyer wrote:
> Hello,
> I'm starting a new project with an Olimex A20 lime2 board.
> Up to now I used the old way of loading the kenrel from u-boot, where I can
> also pass kernel command line and device tree blobs.
> I though that for this new projet I would start with a fresh install,
> and so with EFI. But I didn't find much informations about it.
> 
> What is the way to load a specific device tree, and set some kernel
> boot options ?

I have Olimex A20 lime2 board too---I took your advice on them and I'm
quite satisfied of them---and I have freshly bought EFI books.

I will give it a try in the following days (whether on Sunday or on
Monday) and will report back.

Best,
-- 
        Thierry Laronde <tlaronde +AT+ polynum +dot+ com>
                     http://www.kergis.com/
                    http://kertex.kergis.com/
                       http://www.sbfa.fr/
Key fingerprint = 0FF7 E906 FBAF FE95 FD89  250D 52B1 AE95 6006 F40C