How to get NetBSD to use a DTB file

[Jason Mitchell <jmitchel%bigjar.com@localhost>]

Hello,

    I'm trying to get NetBSD running on two ARM boards from friendlyarm 
-- the Nanopi R2S, which has 2 ethernet ports and the M4V2, which is 
just like the M4 except it has LP-DIMM4 memory instead of LP-DIMM3.

   Here's my boot.cfg:

dtb rk3328-nanopi-r2-rev20.dtb
dtb rockchip/rk3328-nanopi-r2-rev20.dtb
dtb dtb/rockchip/rk3328-nanopi-r2-rev20.dtb

    I've also dropped the dtb file into /efi/boot/ on the DOS partition 
as well as the root of the DOS partition and the NetBSD root.

A big problem with these boards is that they have a default baud rate of 
1500000 for the debug port, so I can't enter boot commands directly -- I 
have to put them in boot.cfg (or somewhere else).

    Thanks for reading!
--
Thanks,

*Jason Mitchell*
bigjar systems
5305 Village Center Drive | Suite 127 | Columbia, MD 21044
www.bigjar.com <http://www.bigjar.com> p: 443.430.9739 | f: 443-583-0289 
| c: 410-921-0272
“THINK GREEN…and print this email only if necessary. Doing the Right 
Things to Make a Difference”.