Port-arm archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: Status of run0 on armv7 NetBSD 8.0_RC1 rpi2



On Mon, Jun 11, 2018 at 09:19:05PM +0530, Mayuresh wrote:
> # wpa_cli status
> Selected interface 'run0'
> 20:31:07.754: wpa_state=SCANNING
> address=00:c1:00:c1:94:b6
> 
> wpa_cli status always shows scanning only.

You can make wpa more informative by running it like this:
wpa_supplicant -i run0 -c /etc/wpa_supplicant.conf # -d extra noisy and
probably not needed

Most notably, I have this problem if people setup the AP in 802.11n only
mode. It is visible only when scanning but authentication times out.
NetBSD does not support 802.11n yet. I've had to change APs to
"802.11b/g/n compatibility mode" a few times.


Home | Main Index | Thread Index | Old Index