Port-arm archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

No ethernet card with Olimex Lime 2



Hi

As specified on September 2014, the Olimex OLinuXino Lime 2 can be booted with the Cubieboard kernel. I compiled it with sources available at https://github.com/jsonn/src (from the 05/23/2015).

It boots but I have no other card than lo printed by ifconfig, and dmesg returns me for awge0 :

awge0 at awinio0: Gigabit Ethernet Controller
awge0: interrupting on irq 117
awge0: reset timed out

Does anyone have the ethernet card working for this board ?

Thank you !

Regards,
	Picani


The complete dmesg output :

Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 7.0_BETA (CUBIEBOARD) #2: Sat May 23 11:41:03 CEST 2015
	picani@netbsd-current:/usr/src/obj_dir/sys/arch/evbarm/compile/CUBIEBOARD
total memory = 1024 MB
avail memory = 1008 MB
sysctl_createv: sysctl_create(machine_arch) returned 17
kern.module.path=/stand/evbarm/7.0/modules
timecounter: Timecounters tick every 10.000 msec
mainbus0 (root)
cpu0 at mainbus0 core 0: 960 MHz Cortex-A7 r0p4 (Cortex V7A core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: isar: [0]=0x2101110 [1]=0x13112111 [2]=0x21232041 [3]=0x11112131, [4]=0x10011142, [5]=0
cpu0: mmfr: [0]=0x10101105 [1]=0x40000000 [2]=0x1240000 [3]=0x2102211
cpu0: pfr: [0]=0x1131 [1]=0x11011
cpu0: 32KB/32B 2-way L1 VIPT Instruction cache
cpu0: 32KB/64B 4-way write-back-locking-C L1 PIPT Data cache
cpu0: 256KB/64B 8-way write-through L2 PIPT Unified cache
vfp0 at cpu0: NEON MPE (VFP 3.0+), rounding, NaN propagation, denormals
vfp0: mvfr: [0]=0x10110222 [1]=0x11111111
cpu1 at mainbus0 core 1
armperiph0 at mainbus0
armgic0 at armperiph0: Generic Interrupt Controller, 160 sources (151 valid)
armgic0: 32 Priorities, 128 SPIs, 7 PPIs, 16 SGIs
armgtmr0 at armperiph0: ARMv7 Generic 64-bit Timer (24000 kHz)
armgtmr0: interrupting on irq 27
timecounter: Timecounter "armgtmr0" frequency 24000000 Hz quality 500
awinio0 at mainbus0: A20 (0x1651)
awingpio0 at awinio0
awindma0 at awinio0: DMA
awindma0: interrupting on irq 59
awincnt0 at awinio0
timecounter: Timecounter "CNT64" frequency 24000000 Hz quality 900
com0 at awinio0 port 0: ns16550a, working fifo
com0: console
awindebe0 at awinio0 port 0: Display Engine Backend (BE0)
awintcon0 at awinio0 port 0: LCD/TV timing controller (TCON0)
awinhdmi0 at awinio0: HDMI 1.3
awinwdt0 at awinio0: default period is 10 seconds
awinrtc0 at awinio0: RTC
awinusb0 at awinio0 port 0
awinusb0: no restrict gpio found
ohci0 at awinusb0: OHCI USB controller
ohci0: OHCI version 1.0
usb0 at ohci0: USB revision 1.0
ohci0: interrupting on irq 96
ehci0 at awinusb0: EHCI USB controller
ehci0: EHCI version 1.0
ehci0: companion controller, 1 port each: ohci0
usb1 at ehci0: USB revision 2.0
ehci0: interrupting on irq 71
awinusb1 at awinio0 port 1
awinusb1: no restrict gpio found
ohci1 at awinusb1: OHCI USB controller
ohci1: OHCI version 1.0
usb2 at ohci1: USB revision 1.0
ohci1: interrupting on irq 97
ehci1 at awinusb1: EHCI USB controller
ehci1: EHCI version 1.0
ehci1: companion controller, 1 port each: ohci1
usb3 at ehci1: USB revision 2.0
ehci1: interrupting on irq 72
motg0 at awinio0: OTG
motg0: interrupting at irq 70
motg0: no restrict gpio found
motg0: Dynamic FIFO sizing detected, assuming 16Kbytes of FIFO RAM
usb4 at motg0: USB revision 2.0
awinmmc0 at awinio0 port 0: SD3.0 (DMA)
awinmmc0: interrupting at irq 64
ahcisata0 at awinio0: AHCI SATA controller
ahcisata0: interrupting on irq 88
ahcisata0: ignoring broken port multiplier support
ahcisata0: AHCI revision 1.10, 1 port, 32 slots, CAP 0x6f24ff80<CCCS,PSC,SSC,PMD,SAM,ISS=0x2=Gen2,SCLO,SAL,SALP,SSS,SSNTF,SNCQ>
atabus0 at ahcisata0 channel 0
awiniic0 at awinio0 port 0: Marvell TWSI controller
awiniic0: interrupting on irq 39
iic0 at awiniic0: I2C bus
awge0 at awinio0: Gigabit Ethernet Controller
awge0: interrupting on irq 117
awge0: reset timed out
awinac0 at awinio0: CODEC
audio0 at awinac0: full duplex, playback, capture, mmap, independent
awinhdmiaudio0 at awinio0: HDMI 1.3
audio1 at awinhdmiaudio0: half duplex, playback, mmap
awinnand0 at awinio0
awinir0 at awinio0 port 0: IR
awinir0: interrupting on irq 37
cir0 at awinir0
gpio0 at awingpio0: 18 pins
gpio1 at awingpio0: 25 pins
gpio2 at awingpio0: 28 pins
gpio3 at awingpio0: 12 pins
gpio4 at awingpio0: 12 pins
gpio5 at awingpio0: 28 pins
gpio6 at awingpio0: 22 pins
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
cpu1: 960 MHz Cortex-A7 r0p4 (Cortex V7A core)
cpu1: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu1: isar: [0]=0x2101110 [1]=0x13112111 [2]=0x21232041 [3]=0x11112131, [4]=0x10011142, [5]=0
cpu1: mmfr: [0]=0x10101105 [1]=0x40000000 [2]=0x1240000 [3]=0x2102211
cpu1: pfr: [0]=0x1131 [1]=0x11011
cpu1: 32KB/32B 2-way L1 VIPT Instruction cache
cpu1: 32KB/64B 4-way write-back-locking-C L1 PIPT Data cache
cpu1: 256KB/64B 8-way write-through L2 PIPT Unified cache
vfp1 at cpu1: NEON MPE (VFP 3.0+), rounding, NaN propagation, denormals
vfp1: mvfr: [0]=0x10110222 [1]=0x11111111
sdmmc0 at awinmmc0
uhub0 at usb0: Allwinner OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 1 port with 1 removable, self powered
uhub1 at usb1: Allwinner EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub1: 1 port with 1 removable, self powered
uhub2 at usb2: Allwinner OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 1 port with 1 removable, self powered
uhub3 at usb3: Allwinner EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub3: 1 port with 1 removable, self powered
uhub4 at usb4: Mentor Graphics MOTG root hub, class 9/0, rev 1.00/1.00, addr 1
uhub4: 1 port with 1 removable, self powered
ld0 at sdmmc0: <0x03:0x5344:SL16G:0x80:0xb0c717ed:0x0f3>
ld0: 15193 MB, 7717 cyl, 64 head, 63 sec, 512 bytes/sect x 31116288 sectors
ld0: 4-bit width, bus clock 50.000 MHz
boot device: <unknown>
root device: ld0a
dump device (default ld0b): 
file system (default generic): 
root on ld0a dumps on ld0b
root file system type: ffs
WARNING: preposterous TOD clock time
WARNING: using filesystem time
WARNING: CHECK AND RESET THE DATE!
init path (default /sbin/init): 
init: trying /sbin/init

Attachment: signature.asc
Description: This is a digitally signed message part.



Home | Main Index | Thread Index | Old Index