RE: TS7200 panic on 5.1.0

[Joel <idatum%comcast.net@localhost>]

As a twist, I have the 16 meg rom version, which needs a different reloc address. It ran for months on 5.0.

Is the trouble you have the install kernel not loading?

---

From: Patrick Collins
Sent: Tuesday, December 14, 2010 4:50
To: idatum
Cc: port-arm%netbsd.org@localhost
Subject: Re: TS7200 panic on 5.1.0

I'm pretty impressed that you got this far. All my previous attempts to get 5.0 running on the TS7200 failed.

Patrick Collins
+61 419 712 581

The woods are lovely, dark, and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep.

On 13 December 2010 03:59, idatum <idatum%comcast.net@localhost> wrote:

I just installed NetBSD 5.1 on a TS7200. I built the kernel with a trimmed down .../evbarm/conf/TS7200 kernel config (attached). Every so often on reboot, I get a fatal kernel error (see below). It also happened once while installing a package.

 

How can I start debugging this?

 

If possible, please point me to some resources to read up on to get me started with landing this in a debugger.

 

Thanks – Joel

 

Here’s some version info:

 

kern.ostype = NetBSD

kern.osrelease = 5.1.0_PATCH

kern.osrevision = 501000000

kern.version = NetBSD 5.1.0_PATCH (TS7200) #3: Fri Dec 10 21:22:59 PST 2010

...

 

Here’s the error:

 

NetBSD 5.1.0_PATCH (TS7200) #3: Fri Dec 10 21:22:59 PST 2010

 

Welcome to NetBSD!

 

Fatal kernel mode data abort: 'Alignment Fault 3'

trapframe: 0xc291dd2c

FSR=00000003, FAR=43414351, spsr=20000013

r0 =c106fff0, r1 =c03f4eac, r2 =43414341, r3 =c1040000

r4 =00000001, r5 =00000000, r6 =c03f4fe4, r7 =00000000

r8 =c1040010, r9 =c03f4eac, r10=00000000, r11=c291dde0

r12=00000000, ssp=c291dd78, slr=c1040010, pc =c02aff30

 

panic: Fatal abort

 

dump to dev 16,1 not possible

 

rebooting...