Port-amiga archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

AW: Problems with grfcv3d



>>Hmm, I'm pretty sure that at some point I used CV64/3D in 16-bit modes in
my A3000. I'm not sure if >>I ever tested 24-bit. 


>The driver code shows that there is some confusion about endianess. I could
imagine that there is >some hardware byte swapping done on the Z2 bus that
is done differently for Z3. The X11 driver would >not know this.

So for my understanding, it is a Zorro II problem with the driver ?
Originally Z2 functionality was disabled in grfcv3d, till Frank enabled it
for me October 2012. There were no additional changes made in the driver as
far as I know.

So nobody could see this problem before. 



Home | Main Index | Thread Index | Old Index