Problems with X11 (install.x11 didn't helps me)

["Alfio Lo Castro" <alfio%ede.it@localhost>]

>On Mon, Aug 31, 1998 at 06:45:58PM +0200, Markus Illenseer wrote:
>> > I have installed NetBSD on my A4000 (060 and CV64 3D),
>> > but after installing X11 I have a trouble....
>> > after typing "startx" the HD works a lot and so the system hangs,
>>
>>  I hope you have read the INSTALL.X11 manual?
>>
>>  a) Do you have setup the grfconfig to install the resolutions?
>>  b) Does your startx include a mode option for the graphic board?
>>  c) Does your startx include a device option for the graphic board?
>>  d) What is beeing displayed on the screen after you startx' ?
>>  e) Does "ctrl alt del" brings you back to the text console?
>                        ________
>Ctrl-Alt-Backspace (the|<---    |  key ).
>                        --------
>
> -is

Thanks,
Unfortunally my backspace is "out of order", but i have verified that
1) my ld.so.conf shares all library and all xinit files have the right
parameters (INSTALL.X11 dixit)...
2) Grfconfig installs on startup the right video modes but...
when i start 'startx' i have some error messages and then the system hangs.
If i config X with "-dev /dev/grf0 -depth 680 -height 540 -depth
4 -emulatemiddle" the error is: 'Warning: cannot allocate colormap entry for
"color" and twm: unable to allocate color "gray70" and then hangs...
If i config "X with -dev /dev/grf7 -mode 2 -emulatemiddle" (640x480 8 bit)
the monitor turns to stand-by mode (is a Trust 17") and the system hangs...
(I have already verified that the mode have the correct parameters and that
CV3D starts well)
help me!

Best regards, Alfio