Port-amiga archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
Re: Fas216 and Caliper 150 ?
Hi Ruben,
>
> > > st0(bzivsc0:4:0): Check Condition on opcode 0x1e
> > > SENSE KEY: Illegal Request
> > > COMMAND INFO: 524288 (0x80000)
> > > ASC/ASCQ: No Additional Sense Information
> > >
> > >
> > >
> > > The tape condition codes resulted from a 'mt rewind' command
> > > Any clue on this one ?
>
> Ok. Would the tape rewind anyway?
> If not: does "echo < /dev/rst0" work? (rewind for the poor)
So, I just found the code place where this is called from.
Apparently, in the new scsi code
a) the st_mount / st_unmount calls try to block the door, if any, (indirectly)
using this opcode. Any error from this is ignored, however.
[src/sys/dev/scsipi, around line 721]
b) the new scsi code is more verbose about raw SCSI error codes, at least with
the GENERIC kernel.
I think you can savely ignore this messages, they are only logged to the
console, the tape should rewind anyway.
-is
Home |
Main Index |
Thread Index |
Old Index