Port-alpha archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

can't reboot after running a 5.0 kernel



Hi-

    I've got a system that identifies itself as:

Digital AlphaStation 600 5/266, 266MHz, s/n 
cpu0 at mainbus0: ID 0 (primary), 21164-5


    It is currently running 4.0 fine (reboots cleanly, etc.).

    If I boot at 5.0 kernel on it and attempt a reboot, I get the 
following:

# halt
Jan 27 10:19:23 halt: halted by root
syncing disks... done
unmounting file systems... done
halted.


halted CPU 0

halt code = 5
HALT instruction executed
PC = fffffc0000300128
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pka0.7.0.1001.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
waiting for pkb0.7.0.1002.0 to start...
>>>
>>>
>>>boot
(boot dka100.1.0.1001.0 -flags a)
failed to open dka100.1.0.1001.0
>>>


If I cycle the power, it boots fine once again.   My guess is that the 
5.0 kernel is leaving the pka0 device in a bad state.   I only get the 
"waiting for pka0.7.0.1001.0 to start..." errors after running the 5.0
kernel (4.0 kernel is fine).

Any ideas on what is causing this problem?   

chuck  (dmesg output is below)



NetBSD 4.0.0_PATCH (GENERIC.MP) #0: Tue May 20 16:45:50 EDT 2008
Digital AlphaStation 600 5/266, 266MHz, s/n 
8192 byte page size, 1 processor.
total memory = 704 MB
(2176 KB reserved for PROM, 701 MB used by NetBSD)
avail memory = 681 MB
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164-5
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (ALCOR/ALCOR2), pass 2
pci0 at cia0 bus 0
pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok
tlp0 at pci0 dev 7 function 0: DECchip 21140 Ethernet, pass 1.2
tlp0: broken MicroWire interface detected; setting SROM size to 1Kb
tlp0: interrupting at kn20aa irq 8
tlp0: DEC DE500-XA, Ethernet address 00:00:f8:04:67:93
tlp0: 10baseT, 100baseTX, 100baseTX-FDX, 10baseT-FDX
ppb0 at pci0 dev 8 function 0: Digital Equipment DC21050 PCI-PCI Bridge (rev. 
0x02)
pci1 at ppb0 bus 1
pci1: memory space enabled, rd/line, wr/inv ok
tlp1 at pci1 dev 0 function 0: DECchip 21040 Ethernet, pass 2.4
tlp1: interrupting at kn20aa irq 16
tlp1: Ethernet address 00:00:f8:21:2c:2a
tlp1: 10baseT, 10baseT-FDX, 10base5, manual
isp0 at pci1 dev 1 function 0: QLogic 1020 Fast Wide SCSI HBA
isp0: interrupting at kn20aa irq 17
isp0: invalid NVRAM header
scsibus0 at isp0: 16 targets, 8 luns per target
isp1 at pci1 dev 2 function 0: QLogic 1020 Fast Wide SCSI HBA
isp1: interrupting at kn20aa irq 18
isp1: invalid NVRAM header
scsibus1 at isp1: 16 targets, 8 luns per target
pceb0 at pci0 dev 10 function 0: Intel 82375EB/SB PCI-EISA Bridge (rev. 0x05)
3Com 3CR990-TX-97 10/100 Ethernet with 3XP (ethernet network, revision 0x02) at 
pci0 dev 12 function 0 not configured
eisa0 at pceb0
isa0 at pceb0
lpt0 at isa0 port 0x3bc-0x3bf irq 7
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
pckbc0 at isa0 port 0x60-0x64
attimer0 at isa0 port 0x40-0x43: AT Timer
pcppi0 at isa0 port 0x61
pcppi0: children must have an explicit unit
midi0 at pcppi0: PC speaker (CPU-intensive output)
spkr0 at pcppi0
isabeep0 at pcppi0
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
mcclock0 at isa0 port 0x70-0x71: mc146818 or compatible
pcppi0: attached to attimer0
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
Kernelized RAIDframe activated
scsibus0: waiting 2 seconds for devices to settle...
scsibus1: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 1 lun 0: <SEAGATE, ST373405LC, 0002> disk fixed
sd0: 70007 MB, 29550 cyl, 8 head, 606 sec, 512 bytes/sect x 143374741 sectors
sd0: sync (100.00ns offset 12), 16-bit (20.000MB/s) transfers, tagged queueing
sd1 at scsibus0 target 2 lun 0: <SEAGATE, ST373405LC, 0003> disk fixed
sd1: 70007 MB, 29550 cyl, 8 head, 606 sec, 512 bytes/sect x 143374741 sectors
sd1: sync (100.00ns offset 12), 16-bit (20.000MB/s) transfers, tagged queueing
cd0 at scsibus0 target 5 lun 0: <DEC, RRD45   (C) DEC, 1645> cdrom removable
cd0: async, 8-bit transfers
root on sd0a dumps on sd0b
root file system type: ffs


Home | Main Index | Thread Index | Old Index