Re: modular-xorg installation fails on Dragonfly 1.8.1-RELEASE with pkgsrc-2007Q1

["Siju George" <sgeorge.ml%gmail.com@localhost>]

On 5/1/07, Jeremy C. Reed <reed%reedmedia.net@localhost> wrote:
> Looking again, I think I see another problem ...
>
> On Tue, 1 May 2007, Siju George wrote:
>
> > I was trying to Install modular-xorg-drivers from pkgsrc-2007Q1 on a
> > DragonFly 1.8.1-RELEASE and get the following error ( detailed at the
> > end of mail ).
>
> > => Required installed package kbproto>=1.0.2: kbproto-1.0.3 found
> > => Required installed package xorg-libs>=6.9.0nb2: xorg-libs-6.9.0nb10 found
> > => Required installed package modular-xorg-server>=1.1.1: NOT found
>
> Notice above "xorg-libs-6.9.0nb10" found. That is not modular X.org.
>
> In your mk.conf set:
>
> X11_TYPE=modular
>
> And also do a "bmake clean-depends clean".
>
> X11_TYPE defaults to "xorg" on DragonFly.
>
> Probably there should be some good error message when you attempt to
> mix-and-match old monolithic Xorg with newer modular Xorg. Or maybe the
> builtin.mk or buildlink3.mk files should be setup to not allow old,
> not-good-enough, dependencies to be used.

Thamkyou so much Jeremy and Joerg for the replies :-)

I changed the /etc/mk.conf and put

X11_TYPE=modular     - its was "xorg" before

did a

#bmake clean-depends clean

as you said. Still

#bmake install clean-depends

failed with the same errors :-(

Is there any place else I need to check or change anything?

thankyou so much

Kind Regards

Siju