Re: Reusing CD-RW

[Todd Gruhn <tgruhn2%gmail.com@localhost>]

'cdrecord blank=all' failed
What do you see below?


  gandalf# cdrecord blank=all dev=31,0,0
cdrecord blank=all dev=31,0,0
Cdrecord-ProDVD-ProBD-Clone 3.02 2022/08/18
(amd64-unknown-netbsd10.0.) Copyright (C) 1995-2019 Joerg Schilling
scsidev: '31,0,0'
scsibus: 31 target: 0 lun: 0
Using libscg version 'schily-0.9'.
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'ASUS    '
Identifikation : 'DRW-24F1ST   d  '
Revision       : '1.00'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
cdrecord: Warning: Cannot read drive buffer.
cdrecord: Warning: The DMA speed test has been skipped.
Starting to write CD/DVD/BD at speed 4 in real BLANK mode for single session.
Last chance to quit, starting real write    0 seconds. Operation starts.

On Thu, Jan 16, 2025 at 8:44 AM <ignatios%cs.uni-bonn.de@localhost> wrote:
>
> On Thu, Jan 16, 2025 at 08:18:56AM -0500, Todd Gruhn wrote:
> > >>>  may be cdrecord from console?
> >
> >
> > I did. But I can not  mount the disk. HMMMMMM...
>
> You probably need "cdrecord blank=all" (read the manpage about
> blanking types) first before writing a completely new "session" (as
> opposed to extending a pre-existing session).
>
>         -is