Re: How to setup Realtek 8139 10/100BaseTX cardbus?

[Csányi Pál <csanyipal%gmail.com@localhost>]

Csányi Pál <csanyipal%gmail.com@localhost> ezt írta (időpont: 2019. jan. 11., P, 16:34):
>
> Benny Siegert <bsiegert%gmail.com@localhost> ezt írta (időpont: 2019. jan. 11., P, 15:58):
> >
> > > rtk0 at cardbus1 function 0: Realtek 8139 10/100BaseTX
> >
> > "dhcpcd rtk0" should get you an address.
> I tried that but get the following IP address:
> rtk0 at cardbus1 function 0: Realtek 8139 10/100BaseTX
> rtk0: Ethernet address: 00:0a:cd:17:17:f8
> rlphy0 at rtk0 phy 7: Realtek internal PHY
> rlphy0: 10baseT, 10-baseT-FDX, 100baseTX, 100baseTX-FDX, auto
>
> It does not work, because this is a wrong IP address.
>
> Finally, I tried to reinstall netbsd on to this old laptop, but failed
> to set up the cardbus with the plugin.
> So now I have a broken NetBSD system, because I can' boot it at all.
>
> Why did not set this cardbus the NetBSD installation disk successfully?
> As I know, this cardbus Realtek 8139 is supported by NetBSD, right?

Well, my network card is good. Only the previous netBSD installation
cd was bad. With a good cd I am being installing the system from the
network. My Realtek 8139 network card works fine.

Best, Pali