NetBSD-Users archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: Status of run0 support on NetBSD 8.0_RC1



Just realize the issue is not arm specific, faced the same on amd64.
NetBSD asusnetbsd 8.0_RC1 NetBSD 8.0_RC1 (GENERIC.201804191727Z) amd64


On Mon, Jun 11, 2018 at 09:19:05PM +0530, Mayuresh wrote:
> Just want to check whether run0 is expected to work on the following
> setup:
> 
> # uname -a
> NetBSD armv7 8.0_RC1 NetBSD 8.0_RC1 (RPI2.201804240813Z) evbarm
> 
> 
> # dmesg | grep run0
> run0 at uhub1 port 3
> run0: Ralink (0x148f) 802.11 n WLAN (0x5370), rev 2.00/1.01, addr 4
> run0: MAC/BBP RT5390 (rev 0x0502), RF RT5592 (MIMO 1T1R), address
> 00:c1:00:c1:94:b6
> run0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
> run0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
> run0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
> 24Mbps 36Mbps 48Mbps 54Mbps
> 
> # wpa_cli status
> Selected interface 'run0'
> 20:31:07.754: wpa_state=SCANNING
> address=00:c1:00:c1:94:b6
> 
> wpa_cli status always shows scanning only.
> 
> I have done /etc/rc.conf and /etc/wpa_supplicant.conf settings as per
> the following link and don't think there is any problem with them:
> https://wiki.netbsd.org/tutorials/how_to_use_wpa_supplicant/
> 
> It had got connected all of a sudden once, something I could not repeat.
> 
> Mayuresh


Home | Main Index | Thread Index | Old Index