NetBSD-Bugs archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
Re: port-sgimips/58269
The following reply was made to PR port-sgimips/58269; it has been noted by GNATS.
From: <iwama%t3.rim.or.jp@localhost>
To: <gnats-bugs%NetBSD.org@localhost>
Cc:
Subject: Re: port-sgimips/58269
Date: Wed, 22 May 2024 06:08:06 +0900
A similar problem occurred on Indigo2 with NetBSD-9.3.
The patch reported in PR #57595 has been applied to this kernel.
>> hinv
System: IP22
Processor: 250 Mhz R4400, with FPU
Primary I-cache size: 16 Kbytes
Primary D-cache size: 16 Kbytes
Secondary cache size: 2048 Kbytes
Memory size: 128 Mbytes
Graphics: High-AA Impact
SCSI CDROM: scsi(0)cdrom(3)
SCSI Disk: scsi(1)disk(1)
SCSI Disk: scsi(1)disk(2)
Audio: Iris Audio Processor: version A2 revision 1.1.0
>> version
PROM Monitor SGI Version 5.3 Rev E IP22 Sep 21, 1995 (BE)
>> boot -f scsi(1)disk(2)rdisk(0)partition(8)aoutboot
scsi(1)disk(2)rdisk(0)partition(0)netbsd.ecoff
54464+0+1792 entry: 0x88002000
NetBSD/sgimips 9.3 Bootstrap, Revision 1.5 (Mon Aug 28 04:30:32 UTC 2023)
devopen: scsi(1)disk(2)rdisk(0)partition(0) type scsi file netbsd.ecoff
4930320+127472=0x4b3b10
[ 1.0000000] [ Kernel symbol table invalid! ]
[ 1.0000000] phys segment: 0xe000 @ 0x8002000
[ 1.0000000] adding 0xe000 @ 0x8002000 to freelist 0
[ 1.0000000] phys segment: 0x730000 @ 0x8010000
[ 1.0000000] adding 0x58000 @ 0x8010000 to freelist 0
[ 1.0000000] adding 0x22c000 @ 0x8514000 to freelist 0
[ 1.0000000] phys segment: 0x7800000 @ 0x8800000
[ 1.0000000] adding 0x7800000 @ 0x8800000 to freelist 0
[ 1.0000000] Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003,
2004, 2005,
[ 1.0000000] 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014,
2015, 2016, 2017,
[ 1.0000000] 2018, 2019, 2020, 2021, 2022
[ 1.0000000] The NetBSD Foundation, Inc. All rights reserved.
[ 1.0000000] Copyright (c) 1982, 1986, 1989, 1991, 1993
[ 1.0000000] The Regents of the University of California. All rights
reserved.
[ 1.0000000] NetBSD 9.3 (GENERIC32_IP2x) #4: Mon Aug 28 19:29:26 JST 2023
[ 1.0000000]
iwama%netbsd-v.led.t3.rim.or.jp@localhost:/home/iwama/NetBSD-9.3-sgimips-indigo2/usr/o
bj/sys/arch/sgimips/compile/GENERIC32_IP2x
[ 1.0000000] total memory = 128 MB
[ 1.0000000] (768 KB reserved for ARCS)
[ 1.0000000] avail memory = 120 MB
[ 1.0000000] WARNING: module error: built-in module sequencer can't find
builtin dependency `midi'
[ 1.0000000] WARNING: module error: built-in module sequencer prerequisite
midi failed, error 2
[ 1.0000000] mainbus0 (root): SGI-IP22 [SGI, 6909b2c8], 1 processor
[ 1.0000000] cpu0 at mainbus0: MIPS R4400 CPU (0x460) Rev. 6.0 with MIPS
R4010 FPC Rev. 0.0
[ 1.0000000] cpu0: 48 TLB entries, 16MB max page size
[ 1.0000000] cpu0: 16KB/16B direct-mapped L1 instruction cache
[ 1.0000000] cpu0: 16KB/16B direct-mapped write-back L1 data cache
[ 1.0000000] cpu0: 2048KB/128B direct-mapped write-back L2 unified cache
[ 1.0000000] ioc0 at mainbus0 addr 0x1fbd9800: rev 0, machine Indigo2
(Fullhouse), board rev 0
[ 1.0000000] int0 at mainbus0 addr 0x1fbd9000
[ 1.0000000] int0: bus 125MHz, CPU 250MHz
[ 1.0000000] imc0 at mainbus0 addr 0x1fa00000: revision 3, EISA bus
present
[ 1.0000000] gio0 at imc0
[ 1.0000000] unknown GIO card (product 0x10 revision 0x01) at gio0 slot 0
addr 0x1f000000 not configured
[ 1.0000000] Synchronous ISDN (product 0x04 revision 0x00) at gio0 slot 1
addr 0x1f400000 not configured
[ 1.0000000] hpc0 at gio0 addr 0x1fb80000: SGI HPC3 (onboard)
[ 1.0000000] zsc0 at hpc0 offset 0x59830
[ 1.0000000] zstty0 at zsc0 channel 1 (console i/o)
[ 1.0000000] zstty1 at zsc0 channel 0
[ 1.0000000] pckbc0 at hpc0 offset 0x59840
[ 1.0000000] pckbd0 at pckbc0 (kbd slot)
[ 1.0000000] wskbd0 at pckbd0 mux 1
[ 1.0000000] pms0 at pckbc0 (aux slot)
[ 1.0000000] wsmouse0 at pms0 mux 0
[ 1.0000000] sq0 at hpc0 offset 0x54000: SGI Seeq 80c03
[ 1.0000000] sq0: Ethernet address 08:00:69:09:b2:c8
[ 1.0000000] wdsc0 at hpc0 offset 0x44000: WD33C93B (20.0 MHz clock, BURST
DMA, SCSI ID 0)
[ 1.0000000] wdsc0: microcode revision 0x0d, Fast SCSI
[ 1.0000000] scsibus0 at wdsc0: 8 targets, 8 luns per target
[ 1.0000000] wdsc1 at hpc0 offset 0x4c000: WD33C93B (20.0 MHz clock, BURST
DMA, SCSI ID 0)
[ 1.0000000] wdsc1: microcode revision 0x0d, Fast SCSI
[ 1.0000000] scsibus1 at wdsc1: 8 targets, 8 luns per target
[ 1.0000000] haltwo0 at hpc0 offset 0x58000: HAL2 revision 1.1.0
[ 1.0000000] audio0 at haltwo0: playback
[ 1.0000000] audio0: slinear_be:16 2ch 48000Hz, blk 4096 bytes (21.3ms)
for playback
[ 1.0000000] spkr0 at audio0: PC Speaker (synthesized)
[ 1.0000000] wsbell at spkr0 not configured
[ 1.0000000] pi1ppc0 at hpc0 offset 0x59800
[ 1.0000000] pi1ppc0: capabilities=0x8<PS2>
[ 1.0000000] ppbus0 at pi1ppc0
[ 1.0000000] ppbus0: No IEEE1284 device found.
[ 1.0000000] lpt0 at ppbus0: port mode = 0x1<COMPATIBLE>
[ 1.0000000] dsclock0 at mainbus0 addr 0x1fbe0000
[ 1.0000030] scsibus0: waiting 2 seconds for devices to settle...
[ 1.0692438] scsibus1: waiting 2 seconds for devices to settle...
[ 1.2513932] pid 0(system): trap: cpu0, TLB miss (load or instr. fetch) in
kernel mode
[ 1.2513932] status=0x4ff03, cause=0x8, epc=0x88428100, vaddr=0
[ 1.2513932] tf=0x88003c78 ksp=0x88003d18 ra=0x88335f28 ppl=0x8850c9d0
[ 1.2513932] kernel: TLB miss (load or instr. fetch) trap
Stopped in pid 0.1 (system) at 88428100: lbu t0,0(a0)
db>
>> boot -f scsi(1)disk(2)rdisk(0)partition(8)boot
scsi(1)disk(2)rdisk(0)partition(0)netbsd
NetBSD/sgimips 9.3 Bootstrap, Revision 1.5 (Mon Aug 28 04:30:32 UTC 2023)
devopen: scsi(1)disk(2)rdisk(0)partition(0) type scsi file netbsd
4930320+127472 [285568+277869]=0x55cc38
Exception: <vector=UTLB Miss>
Status register: 0x2<IPL=8,MODE=KERNEL,EXL>
Cause register: 0x30008008<CE=3,IP8,EXC=RMISS>
Exception PC: 0x0, Exception RA: 0x882f12cc
exception, bad address: 0x0
Local I/O interrupt register 2: 0xc8 <EISA,SLOT0,SLOT1>
Saved user regs in hex (&gpda 0xa8740e48, &_regs 0xa8741048):
arg: a8740000 0 5f 2
tmp: a8740000 27c0 41ef 88578ec8 88578ec8 88575228 88578ec8 4
sve: a8740000 0 0 0 0 0 0 0
t8 a8740000 t9 0 at 0 v0 0 v1 0 k1 88510000
gp a8740000 fp 0 sp 0 ra 0
PANIC: Unexpected exception
[Press reset or ENTER to restart.]
I get around this problem by putting the kernel in IRIX's / partition and
starting it using sash.
--
Yoshihiko Iwama
Home |
Main Index |
Thread Index |
Old Index