Re: install/49470: NetBSD 9.0 RC1 reboots after bootloader (HP Compaq 6005 Pro / AMD Phenom II)

[Matthias Petermann <mp%petermann-it.de@localhost>]

The following reply was made to PR install/49470; it has been noted by GNATS.

From: Matthias Petermann <mp%petermann-it.de@localhost>
To: Andrew Doran <ad%netbsd.org@localhost>
Cc: Andrius V <vezhlys%gmail.com@localhost>, Paul Goyette <paul%whooppee.com@localhost>,
 install-manager%netbsd.org@localhost, gnats-admin%netbsd.org@localhost, netbsd-bugs%netbsd.org@localhost,
 gnats-bugs%netbsd.org@localhost
Subject: Re: install/49470: NetBSD 9.0 RC1 reboots after bootloader (HP Compaq
 6005 Pro / AMD Phenom II)
Date: Fri, 13 Dec 2019 11:40:22 +0100

 Hi Andrew,
 
 thanks again for your guidance. As you recommended I applied the 
 dobeep() calls also to the assembly part (locore.S).
 
 The results are similiar. On the affected system - no beeps are heard
 at all, instead it reboots immediately and without noticeably delay 
 after the line looking like this:
 
 	18611208+666816+1430336 [886040+1244352+888633]=0x16e1ac0
 
 On the other test machine (different vendor) the same kernel produces 
 the beeps as expected, while taking noticeably longer until the green 
 messages occur (I assume this is intended and caused by the beeps). So 
 it seems to not even enter the kernel. You mentioned you might have some 
 hint how to apply the debugging code to the boot loader, which I would 
 like to come back to now.
 
 Kind regards
 Matthias